Bedienungsanleitung NAD M17 AV (Seite 21 von 38) (Englisch)

562261

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

SETTING SPEAKER LEVELS AT TEST MODE

While at “Speaker Levels” menu, press the HTRM 2 remote’s [TEST] key

activating the M17’s Speaker Levels balancing test signal. You will hear a

“surf” sound as you step through your speakers (“test” appears to the right

side of the current speaker), beginning with the Front Left. If you do not

hear the test signal, check your speaker connections or your “Speaker Setup”

OSD menu settings.

Use the remote’s [R/T] keys to adjust the loudness of the noise output

from the currently playing channel to the required level (it’s usually

simplest to begin with the Front Left). As you cycle the test signal around

the speakers, the OSD will highlight the currently playing channel. The

“level oset” reading on the right will change by 0.5dB increments; ±12 dB

adjustment is available. Press “ENTER” to adjust the next speaker.

NOTE

If you are balancing levels “by ear”, choose one speaker—usually the

center—as a reference and adjust each of the others in turn to “sound as

loud” as the reference. Be sure that you remain in the primary listening

position while balancing all channels.

To produce the same SPL meter reading (or subjective loudness), use the

remote’s [R/T] keys to adjust each speaker.

NOTES

• All speakers must be in their nal locations before level-setting.

• Your subwoofer (if any) should be set with its integral crossover defeated,

or if undefeatable, set to its highest-possible frequency if you are using

the M17’s Subwoofer output. Final subwoofer-level adjustment “by-ear,”

using music and lm sound material, is frequently useful.

• Due to the eects of room acoustics, matched-pair speakers (front;

surround; back) will not always calibrate to exactly the same level oset

readings.

You can exit “Test” mode at any time by pressing [W] key, bringing you back

to “Speaker Setup” menu. You can also press the [TEST] key to discontinue

the “Test” mode.

SPEAKER DISTANCE

Your system’s speaker distance settings are a subtle but important

renement of your setup. Informing the M17 of the loudspeaker-to-listener

dimensions of each speaker automatically imposes the correct delays,

optimizing imaging, intelligibility and surround-sound ambience. Enter your

dimensions with precision within about 1 foot (30 cm).

SETTING SPEAKER DISTANCE

While at “Speaker Distance” menu, use the [R/T] keys to individually

set Front Left, Center, Front Right, Surround Right, Back Right, Back Left,

Surround Left and Subwoofer to the distance measuring from your

principal listening position to the front surface of their corresponding

loudspeakers. Distance can be set up to 30 feet or 9.1 meters Distance can

be displayed as feet or meters selectable at the “Unit of Measure” item.

ADJUSTING THE VOLUME

In addition to the Volume knob, use the HTRM 2’s [VOL R/T] to adjust the

“master volume” of the M17 raising or lowering the channels altogether. A

momentary key press will change the master volume by 0.5dB increments.

If you hold down [VOL R/T], the master-volume change will “run-on” until

the key is released.

Since recordings vary considerably in overall average level, there is no

imperative to listen at any particular master-volume setting. A setting of

-20.0 dB may sound “as loud” from one CD or DVD as -10.0 dB does from

another.

The M17 will power-up from Standby mode at whatever master volume

setting was last used; however, if the prior setting was greater than -20.0 dB,

the M17 will power up at -20.0 dB. This prevents inadvertently beginning a

session at excessive volume.

MUTING THE SOUND

Use the HTRM 2’s [MUTE] key to silence all channels completely. Muting is

always available regardless of the source or listening mode selections.

NOTES

• Changing input or listening-mode selections does not release muting.

• Pressing HTRM 2’s [VOL R] or rotating the front panel volume knob

clockwise will automatically release the mute function.

OPERATION

USING THE M17  SETUP MENU

HTRM 2

OFF

SOURCE

SSEETTUUPP DDEELLAAYY // PPIICCTTUURREE TTEESSTT // ZZOOOOMM

EEQQ TTOONNEE LL..NNIITTEE

DDIIMMMMEERR

CHANNEL VOLUME

MMUUTTEE

PPRROOGGRRAAMM CCLLEEAARR RREEPPEEAATT

DAC

DEVICE SELECTOR

SSLLEEEEPP

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NAD M17 AV Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von NAD M17 AV

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info