Bedienungsanleitung Nec GT 5000 (Seite 2 von 115) (Englisch)

493541

Zoom out

Zoom in

Vorherige Seite

1/115

Nächste Seite

Important Information

Precautions

Please read this manual carefully before using your NEC GT6000/

GT5000 Projector and keep the manual handy for future refer-

ence.

Your serial number is located on the bottom of your GT6000/

GT5000. Record it here:

If you are a user of the GT6000R, read the supplied document

which describes the differences from the GT6000.

CAUTION

To turn off main power, be sure to remove the plug

from power outlet.

The power outlet socket should be installed as near

to the equipment as possible, and should be easily

accessible.

CAUTION

TO PREVENT SHOCK, DO NOT OPEN THE CABI-

NET.

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED NEC SER-

VICE PERSONNEL.

This symbol warns the user that uninsulated volt-

age within the unit may be sufficient to cause elec-

trical shock. Therefore, it is dangerous to make any

kind of contact with any part inside of the unit.

This symbol alerts the user that important informa-

tion concerning the operation and maintenance of

this unit has been provided. The information should

be read carefully to avoid problems.

WARNING

TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT

TO RAIN OR MOISTURE.

DO NOT USE THIS UNIT’S GROUNDED PLUG WITH AN EX-

TENSION CORD OR IN AN OUTLET UNLESS ALL THREE

PRONGS CAN BE FULLY INSERTED.

DO NOT OPEN THE CABINET. THERE ARE HIGH-VOLTAGE

COMPONENTS INSIDE. ALL SERVICING MUST BE DONE BY

QUALIFIED NEC SERVICE PERSONNEL.

DOC Compliance Notice

This Class B digital apparatus meets all requirements of the Ca-

nadian Interference-Causing Equipment Regulations.

3. GSGV Acoustic Noise Information Ordinance:

The sound pressure level is less than 70 dB (A) according to ISO

3744 or ISO 7779.

In UK, a BS approved power cable with moulded plug has a Black

(five Amps) fuse installed for use with this equipment. If a power

cable is not supplied with this equipment please contact your

supplier.

• IBM is a registered trademark of International Business Machines Cor-

poration.

• Macintosh and PowerBook are registered trademarks of Apple Com-

puter, Inc.

• Other product and company names mentioned in this user's manual

may be the trademarks of their respective holders.

RF Interference

WARNING

The Federal Communications Commission does not allow any

modifications or changes to the unit EXCEPT those specified by

NEC Solutions, Inc. in this manual. Failure to comply with this

government regulation could void your right to operate this equip-

ment.

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protec-

tion against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the in-

structions, may cause harmful interference to radio communica-

tions. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio / TV technician for help.

Important Safeguards

These safety instructions are to ensure the long life of your projector

and to prevent fire and shock. Please read them carefully and heed

all warnings.

Installation

1. For best results, use your projector in a darkened room.

2. Place the projector on a flat, level surface in a dry area away from

dust and moisture. Tilting the front of the projector up or down by

more than 45° from level could reduce lamp life by up to 20%.

3. Do not place your projector in direct sunlight, near heaters or heat

radiating appliances.

4. Exposure to direct sunlight, smoke or steam can harm internal

components.

5. Handle your projector carefully. Do not hold the lens hood and the

terminal covers. Dropping or jarring can damage internal compo-

nents.

6. Do not place heavy objects on top of the projector.

7. If you wish to have the projector installed on the ceiling:

a. Do not attempt to install the projector yourself.

b. The projector must be installed by qualified technicians in or-

der to ensure proper operation and reduce the risk of bodily

injury.

c. In addition, the ceiling must be strong enough to support the

projector and the installation must be in accordance with any

local building codes.

d. Please consult your dealer for more information.

To Dealer or Installer:

To prevent the projector from falling, install it in a place and fasten it in

a way with sufficient strength to support the combined weight (26.0

kg/57.3 lbs) of the projector (18.4 kg/40.6 lbs), the lens (4.0 kg/8.8

lbs) and the ceiling mount(3.2 kg/7.1 lbs) for an extended period of

time as well as to withstand earthquakes.

Nec GT 5000 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nec GT 5000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info