English English
5 4
English
IMPORT ANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be obser ved, including the
following:
•Read all instructions carefully .
•Do not touch hot sur faces. Use handles or knobs.
•T o protect against risk of fire, electric shock, and injur y to persons do not immerse cord or plug or
appliance in water or any other liquid.
•Close super vision is necessar y when any appliance is used by or near children.
•Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off par ts,
and before cleaning the appliance.
•Do not operate any appliance with a damaged cord or plug, or af ter the appliance malfunctions, or if it is
dropped or damaged in any manner . Return appliance to the nearest authorized Ser vice Center for
examination, repair or electrical or mechanical adjustment.
•The use of accessory attachments not recommended or sold by the appliance manufacturer may result in
fire, electric shock or injury .
•Do not use outdoors.
•Do not let cord hang over edge of table or counter , or touch hot sur faces.
•Do not place on or near a hot gas or electric bur ner , or in a heated oven.
•Always attach plug to appliance first, then plug cord into the wall outlet. T o disconnect, turn any control to
“OFF” or “0”, then remove plug from wall outlet.
•Do not use appliance for other than intended use. The manufacturer cannot be considered responsible for
any damage caused by improper , incor rect or unreasonable use.
SAVE THESE INSTRUCTIONS
CAUTION
•Af ter removing the appliance from the packaging, check it for damage. If in doubt, do not use the appliance
and contact an authorised service centre.
•Plastic bags, polystyrene, nails, etc. must not be lef t within reach of children as they are potentially
dangerous.
•The appliance must be connected to an electrical system and power supply socket with a minimum
capacity of 10A , equipped with an efficient ear th contact. The manufacturer is not responsible for any
damage caused by failure to ear th the system.
•Any repairs must only be car ried out by authorised ser vice centres. (This includes replacement of the
power supply cable, since special tools are required).
•The appliance's manufacturer and vendor reject any responsibility for failure to comply with the
instr uctions provided in this user manual.
•Never operate the appliance without water ; it would be damaged beyond repair .
•Never touch hot par ts of the appliance with bare hands, as burns might result.
•The appliance dispenses hot water and steam, and temperatures are therefore high. T ake great care to
avoid burns.
•Never remove the filter holder when the appliance is pressurized or is dispensing coffee.
•Never leave water inside the appliance at temperatures of 0°C or below .
•Before car r ying out any maintenance or cleaning operations, make sure that the appliance has been
disconnected from the electrical mains by removing the plug from the power supply socket.
•Never wash the appliance using water jets or place it in water!
•Never touch the appliance with wet or damp hands or feet.
PUTTING THE APPLIANCE INTO SERVICE - USING For hygiene reasons, the water in the tank should
IT FOR THE FIRST TIME
also be changed and the washing procedure
carried out if the appliance is lef t unused for more
Wash all the accessories in the packaging carefully .
than a week. In this case, replace the water still in
Remove the tank (1) from its seat and clean it
the tank with fresh water before star ting the
thoroughly . Then fill it with fresh water and put it
cleaning process.
back in place. Caution: take care to fit the filler hose
properly , with no kinks or restrictions which might
ADJUSTING GRINDING (OPERA)
impair water intake.
Fill the container (14) with coffee beans. The
Connect the plug to the power supply socket af ter
numbered scale on the container indicates the
checking that the voltage on the electrical data plate
grinding level setting.
is the same as the mains voltage. Press the master
7 . 6 . 5 . 4 . 3 . 2 . 1
switch (4); the light inside the switch will illuminate
T aking the notch on the frame of the machine as
to show that the appliance is receiving power . Load
reference, tur n the coffee grinding regulator knob
water into water circuit immediately as described
(15) until the number cor responding to the desired
in the paragraph below . Do not let the machine
grinding fineness is in line with the reference notch.
powered without the water circuit loaded.
High numbers give coarser grinding and low
Wash the coffee making unit proceeding as
numbers finer grinding. Setting the cor rect grinding
follows:
fineness is fundamental in obtaining a goods, creamy
Remove the filter holder (11) and press the coffee
cup of coffee. The right setting depends on the
dispenser switch (7); the pump will star t to load
different blends of coffee available on the market and
water . Wait until water flows from the boiler outlet
personal preference.
(10). Now , the appliance's water circuit is now
MAKING ESPRESSO COFFEE
primed.
Make sure that the operations described in the
Press the coffee switch (7) to bring it to the “0”
PUTTING THE APPLIANCE INTO SERVICE section
position and stop the flow .
have been car ried out.
Repeat the operation whenever the appliance's
Wait until the water/steam temperature light (3)
water circuit has to be re-primed because the
goes out, indicating that the appliance is ready to
tank has been emptied completely . Do not let
make coffee (while the appliance is in use, the light
the machine powered without the water circuit
will go on whenever the water temperature drops
loaded.
below the pre-set values. Do not star t to make
For hygiene reasons, the water in the tank should
coffee until the light is off).
also be changed and washing procedure car ried
Place the filter for one cup or for two cups in the filter
out if the appliance is lef t unused for more than a
holder (11).
week. In this case, replace the water still in the
tank with fresh water before star ting the cleaning
OPERA. Place the filter holder against the suppor t
process.
provided under the coffee outlet (16) and press the
button (17) to star t coffee grinding. When the
When the appliance is used for the first time, allow
desired quantity is reached, release the coffee
about a litre of water to flow to ensure it is
grinding button (17).
thoroughly cleaned.
FENICE. Whit the doser measure, place the ground
Then wash the hot water/steam dispenser unit
coffee in the filter (one measure = one cup; two
proceeding as follows:
measures = two cups).
T urn on the steam/hot water tap (5) by tur ning it
Use the presser (8) to press the coffee in the filter
anti-clockwise.
firmly down. The creaminess of the coffee will
Press the hot water dispenser switch (13); the
depend on how the beans have been ground and
pump will star t to load water . W ait until an even jet
how hard the grounds are pressed down (if the
of water , containing no air , flows from the hot
coffee is damp or finely ground, lighter pressure is
water/steam dispenser spout (9).
sufficient, while if it is coarsely ground it requires a
When the appliance is used for the first time, allow
firmer pressure). R emove any excess coffee from
about a litre of water to flow from the steam spout
the rim of the filter .
to ensure it is thoroughly cleaned.
Connect the filter holder (11) under the boiler outlet
Press the hot water switch (13) to bring it to the
(10), tur ning it from lef t to right until it cannot be
"0" position and tur n off the steam/hot water tap
turned any fur ther . Caution : it is impor tant always
(5) by tur ning it clockwise to stop the flow .
to push the filter holder firmly home until it cannot
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•