Bedienungsanleitung Nilfisk IV150 (Seite 40 von 60) (Deutsch, Englisch, Holländisch, Französisch)

19480

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

INSTRUCTIONS FOR USE

10 32401106(1)2004-04 A

CATEGORIES OF USE

Use in compliance with the standards.

Check which category your machine is suited for (see

identification plate).

The machine must not be used for several categories at

the same time, unless suitable accessories are used, such

as liquid kit if the machine is to be used for liquids.

Dust Class “L”

(Light hazard – defined by EN 60335-2-69).

This industrial vacuum is approved according to EN

60335-2-69 for category of use “L” and is fit to suck dry,

non flammable and non-toxic dust with MAK>1mg/m

values; the clean air is conveyed back into the place of

work.

Dust class “M”

(Medium hazard – defined by EN 60335-2-69).

Suitable for removing hazardous, dry, not inflammable

dusts whose MAK limiting value is greater than 0.1 mg/m

Dust class “H”

(High hazard – defined by EN 60335-2-69).

Suitable for removing hazardous, dry, not inflammable

dusts with all MAK limiting values as well as dry, not

inflammable dusts of carcinogenic substances. The

cleaned air is fed back to the workplace atmosphere.

Category of use ATEX

Industrial vacuum cleaners with the additional ATEX

machine type are tested and approved for the removal of

settled inflammable dusts.

Dusts with an extremely low minimal ignition energy (< 1

mJ) like toners, sulphur, aluminium powder or lead

stearate are excluded. In this case, operation requires a

special security consideration.

This vacuum must only be used to clean surfaces. It must

not be used to suction clean moving machines or powders

classified as liable to explode according to explosion

category G, in class ST3, nor inflammable liquids and

inflammable powders mixed with inflammable liquids.

EMPTYING THE CONTAINER

(VERSION H-)

Before emptying, switch off the motor. Shake the filter a

number of times and give the dust time to settle.

Release the container using the lever.

Switch the motor back on and follow these steps:

– remove the container from below the machine;

– close the container “1” lid;

– remove the sealed container “2”;

– insert a new empty container into the dust container

and refit it into the vacuum cleaner.

Carefully check that the waste container (when mounted)

is perfectly tight with the filtering chamber. The elimination

of the container containing toxic substances must be done

following the existing rules.

Using a Dust Safe Bag system, Dust class H.

Fitting the Dust safe Bag

Place the special dust bag flat in the bin with its opening

pointing towards the bin inlet.

Now slide the opening in the special dust bag on to the bin

inlet as far as it will go – without any turning.

Then fold the plastic bag down over the bin rim.

Now pull the part of the plastic bag overlapping the bin rim

tight against the flange (before re-attaching the top and

bottom sections of the vacuum cleaner).

Once the dust bag is full

Leave the hose connected or close to the lid!

After opening the appliance detach the plastic bag lying

across the bin rim carefully, close and seal it.

Detach the back of the connecting flange by briefly

pressing firmly downwards at an angle, while holding the

front firmly on the connection piece.

The plastic-hose joint is now visible and can be tied off

securely with the cable tie simply by pulling it together.

Having thus ensured that no dust can escape, now also

detach the front part of the flange from the connection

piece.

Using a Dust Bag system (plastic bag insert) (Fig. 9)

Having opened the system, remove the plastic bag’s edge

carefully from the container’s rim that it is covering. Close

the bag’s opening and take it out of the container.

Put a new bag into the container. Take care that it fits the

bottom and the walls. Pull the bag’s edge over the

container’s rim and smooth it down.

Dust - Class “L”

Machines of this category of application can be used

without a dust bag. In this case please make sure that the

removal of the dust takes place in a special area and use

a respiratory protection mask.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk IV150 Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nilfisk IV150

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info