Bedienungsanleitung Nova 330300 (Seite 10 von 32) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

46040

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Cyclone Cleaner 2000 Article 330300

1 Adjust the telescopic tube to the

required length (see figure 4). Push the

locking button in the direction indicated

by the arrow on the button. Keep the

locking button pressed and extend or

retract the telescopic tube. Release the

locking button to lock the telescopic

tube to the desired length.

2 Fit the combi nozzle or one of the other

accessories to the end of the tube. You

can also fit the combi nozzle or one of

the other accessories directly to the end

of vacuum cleaner hose handle.

The combi nozzle has two settings: with

a brush for vacuuming hard floors

(parquet, tiles, linoleum, etc.) and

without a brush for vacuuming soft

floors (carpet, etc.). Press the button on

the combi nozzle to either vacuum with

a brush ( ) or without a brush

( ) (see figure 5).

Vacuuming

1 The power cord has a yellow mark and

a red mark on it (see figure 6). Extend

the power cord beyond the yellow mark.

The red mark indicates the end of the

power cord. Never extend the cord

beyond the red mark. This could

damage the power cord.

2 Insert the plug into a plug socket and

press the On/Off switch. Press the On/

Off switch again to turn the appliance

off.

3 Use the handle on the vacuum cleaner

hose to move the appliance back and

forth whilst vacuuming. You can lift the

appliance using the vacuum cleaner’s

handle.

Note! Never lift the vacuum cleaner

using the dust collector's handle!

4 The suction force can be adjusted

whilst vacuuming using the button that

adjusts the suction force. The suction

force can also be temporarily reduced

by opening the air supply control slide

on the vacuum cleaner hose handle.

5 Press the On/Off button to turn the

appliance off.

Accessories

Besides the combi nozzle for cleaning

large surfaces, there are also two

accessories for cleaning smaller and

special surfaces:

• A crevice tool, to clean radiators,

window frames, crevices, small

openings, etc.

• A small nozzle, to clean delicate or

irregular surfaces, furniture, Venetian

blinds, etc.

Storing the appliance

1 Remove the plug from the plug socket.

2 Lightly hold the end of the power cord.

Press the cord rewind button and allow

the cord to gently slide through your

fingers back into the appliance.

Note! You must guide the cord whilst it

is rewinding. If you do not do so, the

cord may become tangled or the plug

may strike the back of the appliance.

This can damage the appliance or the

power cord.

3 Stand the vacuum cleaner upright. Fully

retract the telescopic tube. A slot for the

telescopic tube is located at the bottom

of the vacuum cleaner, next to the front

castor. Slide the holder on the telescopic

tube into the slot (see figure 7). This

avoids the need to dismantle the

vacuum cleaner after use; you can

store the assembled appliance and

retrieve it again quickly when you need

it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nova 330300 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info