Bedienungsanleitung Nuk Eco Control Audio 530D plus - 10256440 (Seite 12 von 22) (Englisch)

803240

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

5. Operating the baby unit

5.1 Switching the baby unit on

and off

The baby unit 1 will switch on automatically

as soon as you have connected the mains

adapter and plugged it into the power

supply. You can subsequently switch the

baby unit on or off at any time:

• To switch the baby unit 1 on or off, press

the On/Off button 7.

5.2 Indicator LEDs

• The Power LED 9 lights up green while

the baby unit is switched on.

• The VOX LED 10 on the baby unit lights

up green when there is an established

connection between it and the parent

unit.

• The VOX LED 10 will not be lit while the

baby unit 1 is switched to Eco-Mode or if

it was not possible to set up a connection

to the parent unit.

5.3 Lullabies

This NUK babyphone has four especially

composed lullabies and soothing natural

sounds to help you soothe your baby and

lull it to sleep.

1. To activate the lullabies on the baby unit 1,

press the Lullabies on/off button 6.

Note: The lullabies can also be activated

from the parent unit 11 (see

"6.8 Lullabies" on page 38).

2. You can change the current song by

holding down the Lullabies on/off

button 6. This automatically goes on to the

next song.

The previously selected lullaby will play in

a loop for about 20 minutes and will then

automatically switch off.

5.4 Nightlight

The baby unit’s soft nightlight helps your

baby recognise things in the dark room,

which it finds soothing.

• You turn the nightlight on or off by briefly

pressing the Nightlight on/off button 8.

Notes:

– If you press and hold the Nightlight

on/off button 8, this activates the

Paging function (see "Call function of

parent unit“ on page34).

– The nightlight can also be activated

from the parent unit 11 (see

"6.9 Nightlight" on page 38).

5.5 Call function of parent unit

If you misplace the parent unit and are

unable to find it, you can use the “Paging”

function to search for it.

1. You activate the function by holding

down the Nightlight on/off button 8.

When the function has been activated,

the baby unit will beep once and the

parent unit will then begin to emit a

continuous series of beeps that will

enable you to locate it.

Notes:

– The parent unit emits these beeps at

the volume you previously selected

(see "6.4 Adjusting the volume control"

on page 36). If the volume is set to its

lowest level, then the beeps will also be

extremely quiet.

– If the parent unit is muted then it will

not emit any beeps; and the baby unit

will emit a double beep to indicate this:



one beep: Search function has been

activated



two beeps: the search function cannot

be activated because there is currently

no connection to the parent unit. The

parent unit is either switched off, or out

of range, or currently muted.

2. You turn the function off either by again

pressing and holding the Nightlight on/

off button 8, or by pressing any of the

buttons on the located parent unit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nuk Eco Control Audio 530D plus - 10256440 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nuk Eco Control Audio 530D plus - 10256440

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info