Bedienungsanleitung Oce OP1016 Operation Guide Command Center (Seite 20 von 25) (Englisch)

47327

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

COMMAND CENTER

6-9 Advanced > Management / E-mail: SMTP E-mail Recepient

When Low Toner or other error occurs, the status information can be sent to a

designated e-mail address at a designated time. Make this setting after making the

SMTP setting.

Authenticate as When POP3 account 1 to 3 is selected, this uses the selected POP3

account to perform SMTP authentication. When Entered below is

selected, the values set for the Login Account Name and Login Password

are used.

that was set here is used for SMTP authentication. Up to 64 characters

can be entered.

was set here is used for authentication.

Sender Address Set the address of the person responsible for the printing system, such as

the printer administrator, so that a reply or non-delivery report will go to a

person rather than to the printer.

Subject This allows setting of the Subject of the report e-mail sent from the system.

Conversion character strings, such as %printer (model name) and %serial

(serial number) can be entered.

Signature Enter the signature. The signature is free form text that will appear at the

end of the e-mail body. It is often used for further identification of the

printing system.

Item Description

Recipient 1 (to 3) Address For Recipient 1 (to 3) Address, enter the e-mail address of the intended

recipient. Entering a distribution list address is a simple way to send to

multiple recipients.

Event Report Items Under Event Report Items, check the box for each type of error condition

to be reported to the recipient.

Event Report Interval Enter the E-mail Interval. An e-mail will be sent at the end of the interval

only when at least one of the selected error conditions has occurred during

the interval. The interval can be set from 1 minute to 1000 minutes. An

event will be reported only when at least one of the selected events occurs

during the interval.

Scheduled Report Items Select one or more items from Printer Status, Network Status, and

Counter Status.

Scheduled Report Interval Sets the time or interval for sending the status information. Events will be

reported at the specified interval.

• None: No report is sent.

• Monthly: Sends on the specified day of specified month.

• Weekly: Sends on the specified day of every week.

• Daily: Sends at the specified time of every day.

• Hourly: Sends at the specified interval every hour.

Note: If a specified day does not exist in the month, such as the 31st, the

last day of the month is used as the specified day.

Run once now Clicking the Sent button sends the event reports and scheduled reports to

the e-mail addresses that were set in Recipient Address regardless of the

Report Interval setting.

Item Description

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oce OP1016 Operation Guide Command Center Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info