Bedienungsanleitung Oce OP40 Operation Guide Scan System Set-up (Seite 13 von 32) (Englisch)

47584

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

2. Set-up

2-3

• Registering and editing user information

The following explains the procedure to use the scanner’s

touch panel to register and edit user information. Registration

of user information is also possible from an Internet Web

browser as well as by using the Address Editor software.

Perform steps 1 through 3 under “Basic scanner

settings” and then touch the “User registr.” key in the

Scanner Setting menu (shown in the screen shot in

step 4). The User Register/Delete screen will appear.

If you want to change previously registered user

information, use the “▲” and “▼” cursor keys to

select the name of the user that you want to edit the

information for and touch the “Change user info.” key.

If a password (see “User registration information” on

page 2-5) has been registered for that user, enter the

registered password. The Edit User Info screen will

appear.

If you want to delete a registered user, use the “▲”

and “▼” cursor keys to select the name of the user

that you want to delete and then touch the “Delete”

key.

Use the “▲” and “▼” cursor keys to select the setting

that you want to change and then touch the “Change

#” key. The Change Settings screen will appear.

Enter the corresponding information in accordance

with the settings, etc., that are shown on the touch

panel.

• For more information on entering characters, refer

to the Operation Guide for your copier.

Use the numeric keys on the keypad to enter the

administrator password number. The factory default

setting for 25 ppm machines is “2500”, for 35 ppm

machines is “3500” and for 40 ppm machines is

“4000”.

* If the entered number matches the registered one,

the Scanner Setting menu will appear.

* It is possible for you to change the administrator

password number as desired. For more information,

refer to the Operation Guide for your copier.

Touch the “System Basic” key. The System Basic

screen will appear.

If “Unable to use scanner” appears, the touch panel

will return to the Default Setting screen. Wait for a

while (approx. 2 minutes) and then touch the “System

Basic” key again.

Use the “▲” and “▼” cursor keys to select the setting

that you want to change and then touch the “Change

#” key. The Character Input screen will appear.

• The following explains the procedure for registering

the scanner’s host name. Refer to this basic

procedure when changing other settings.

Touch the appropriate keys on the displayed key-

board in order to enter the scanner’s host name.

Check the entered name and, once you are certain

that it is correct, touch the “End” key. The touch panel

will return to the System Basic screen.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oce OP40 Operation Guide Scan System Set-up Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info