Bedienungsanleitung Oceanic BUD (Seite 13 von 24) (Englisch)

550354

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

BUD OPERATING MANUAL

NO DECO MAIN, information includes (Fig. 22) -

> DTR (hr:min) with NDC (or O2) icon.

> Current Depth with FT (or M) icon.

> Max Depth with MAX and FT (or M) icons

> EDT (Elapsed Dive Time) with DIVE and min icons

> NX, CF, DSAT (or Z+), icons - those that apply.

> TLBG.

> VARI, while ascending.

• B (< 2 sec) to access ALTs.

Upon ascending to 2 FT (0.6 M) during a dive, Surface Interval time will be displayed with the SURF icon ﬂashing for the ﬁrst 10

minutes with Current Depth displayed as 0 (Fig. 23).

• B (< 2 sec) to access Dive ALTs.

If a descent is made to 5 FT (1.5 M) for 5 seconds during that ﬁrst 10 minutes, the dive will be continued. Surface time will not be added to

Elapsed Dive Time.

After 10 minutes elapse on the surface, operation will revert to the Surface Main with full access given to the other surface items.

NO DECO ALT 1, information includes (Fig. 24) -

> EDT (hr:min) with EDT icon.

> Max Depth with FT (or M) and MAX icons.

• B (< 2 sec) to access ALT 2 if NX, or revert to Main if Air.

• Revert to Main in 5 sec, if B not pressed.

NO DECO ALT 2 (if Nitrox), information includes (Fig. 25) -

> O2 saturation (accumulation) with O2% icon.

> Current PO2 value (ATA) with PO2 icon.

> FO2 Set Point with FO2 and NX icons.

• 5 sec or B (< 2 sec) to revert to Main.

SAFETY STOP MAIN, information includes (Fig. 26) -

> Stop Time (min:sec) with STOP icon, counting down.

> Current Depth with FT (or M) icon.

> Stop Depth with STOP and FT (or M) icons.

> NX, CF, DSAT (or Z+), icons - those that apply.

> TLBG.

• B (< 2 sec) to access ALTs**.

** The SS features up to 3 ALT displays which are similar to the No Deco Main, ALT1, and ALT2 displays, respectively.

DECOMPRESSION

Decompression mode activates when theoretical No Decompression time and depth limits are exceeded.

Upon entry into Deco, the full TLBG will ﬂash (Fig. 27) for 10 seconds. The Stop Depth digits will ﬂash while 10 FT (3 M) below

the required Stop Depth.

> Once within 10 FT (3 M) below the required Stop Depth (stop zone), the Stop Depth digits will stop ﬂashing.

To fulﬁll your decompression obligation, you should make a safe controlled Ascent to a depth slightly deeper than, or equal to,

the required Stop Depth indicated and decompress for the Stop Time indicated.

The amount of decompression credit time that you receive is dependent on Depth, with slightly less credit given the deeper you

are below the Stop Depth indicated.

You should stay slightly deeper than the required Stop Depth indicated until the next shallower Stop Depth appears. Then, you

can slowly ascend to, but not shallower than that indicated Stop Depth.

Fig. 22 - NO DECO MAIN

Fig. 23 - NO DECO MAIN

(on surface < 10 min)

Fig. 24 - NO DECO ALT 1

Fig. 25 - NO DECO ALT 2

Fig. 26 - SS MAIN

Fig. 27 - DECO ENTRY

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oceanic BUD Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Oceanic BUD

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info