Bedienungsanleitung Oceanic OC1 (Seite 37 von 68) (Englisch)

551838

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

OC1 OPERATING MANUAL

VGM Alt 1, information includes (Fig. 97) -

> Max Depth with MAX and FT (or M) icons

> Graphic EDT with Elapsed Dive Time (hr:min)

• A (< 2 sec) to access ALT 2

• Revert to Main in 5 sec, if A not pressed

VGM Alt 2, information includes (Fig. 98) -

> Time of Day (hr:min sec), with A (or P) if 12 Hour

> Temperature with ° icon and graphic F (or C)

• 5 sec or A (< 2 sec), revert to Main

VGM ON SURFACE

The graphic VIOL ﬂashes for the ﬁrst 10 minutes, then it alternates with NORM (each On 3 seconds, Fig. 99A/B) until DC shut

down after 24 hours with no dives.

In the event that a dive is made during the 24 hour period, a full 24 hour surface interval must then be served before all func-

tions are restored.

During that 24 hours, VGM does not allow access to the Set F, Plan, Dsat, and FREE Mode features/screens. All Watch and

Compass functions will be allowed.

The Fly countdown timer provides the time remaining before normal operation can resume with full features and functions.

HIGH PO2

Warning >> at Alarm Set Point value minus .20 (1.00 to 1.40)

Alarm >> at Set Point value, except in Deco then at 1.60 only

When partial pressure of oxygen (PO2) increases to .20 less than the PO2 Alarm Set Point; the Audible sounds, the Up Arrow

icon will ﬂash, and the PO2 value with graphic PO2 will ﬂash (in place of NDC) until the Audible is silenced (Fig. 100).

> After Audible - NDC is restored, Up Arrow icon solid until PO2 decreases below .20 less than the Alarm Set Point.

If PO2 continues to increase and reaches the PO2 Alarm Set Point, the Audible sounds again.

> The PO2 value with graphic PO2 and Up Arrow icon will ﬂash until PO2 decreases below the Alarm Set Point.

PO2 Alarm Main, information includes (Fig. 101) -

> Up Arrow icon, ﬂashing until < Set Point, then solid

> Current Depth with FT (or M) icon

> PO2 value (ATA) with graphic PO2, ﬂashing until < Set Point, then solid

> ATR (min) when 60 minutes or less with graphic ATR and Time (clock) icon, blank if no TMT

> Graphic GAS1 (or 2 or 3), one in use

> Pressure with PSI (or BAR) and Link icons, if Rcvr and TMT are active, ﬂashing when Link is lost

> Nx icon

> TLBG with NI icon

> VARI while ascending

• A (< 2 sec) to access ALTs

• S (< 2 sec) to acknowledge alarms

• S (2 sec) to access Compass

• M (2 sec) to access Gas Switching

• L (closure) to activate Backlight

PO2 Alarm Alt 1, information includes (Fig. 102) -

> Max Depth with MAX and FT (or M) icons

> DTR (hr:min) with graphic NDC (or OTR if less), 0:00 if PO2 is 1.60

> Graphic EDT with Elapsed Dive Time (hr:min)

> Graphic FO2 with Set Point for Gas in use

> Graphic PO2 with current value (ATA)

> Nx icon

> O2BG with O2 icon

• A (< 2 sec) to access ALT 2

• Revert to Main in 5 sec, if A not pressed

Fig. 98 - VGM ALT 2

Fig. 97 - VGM ALT 1

Fig. 99B - VGM SURF MAIN

Fig. 99A - VGM SURF MAIN

Fig. 100 - PO2 WARNING

(during Audible)

Fig. 101 - PO2 ALARM MAIN

Fig. 102 - PO2 ALARM ALT 1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oceanic OC1 Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Oceanic OC1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info