Bedienungsanleitung Oceanic OC1 (Seite 38 von 68) (Englisch)

551838

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

OC1 OPERATING MANUAL

PO2 Alarm Alt 2, information includes (Fig. 103) -

> Time of Day (hr:min sec), with A (or P) if 12 Hour

> Temperature with ° icon and graphic F (or C)

• 5 sec or A (< 2 sec), revert to Main

PO2 during Deco

The PO2 alarm setting does not apply when in Deco.

> If PO2 reaches 1.60 while at a Deco Stop, the PO2 value (1.60) with graphic PO2 will alternate with Deco Stop Depth/

Time once each minute with PO2 on for 10 seconds, Deco on for 50 seconds until PO2 decreases below 1.60, then PO2

will not be displayed.

HIGH O2

Warning >> at 80% (240 OTU)

Alarm >> at 100% (300 OTU)

When O2 accumulation increases to 80%, the Audible sounds, the Up Arrow icon will ﬂash, and the graphic O2 will ﬂash (in

place of NDC) until the Audible is silenced (Fig. 104).

> After Audible - NDC is restored, Up Arrow icon continues to ﬂash until on surface.

If O2 reaches 100%, the Audible sounds again.

> The full O2BG and graphic O2 will be displayed ﬂashing until on the surface.

O2 Alarm Main, information includes (Fig. 105) -

> Up Arrow icon, ﬂashing

> Current Depth with FT (or M) icon

> Graphic O2, ﬂashing

> ATR (min) when 60 minutes or less with graphic ATR and Time (clock) icon, blank if no TMT

> Graphic GAS1 (or 2 or 3), one in use

> Pressure with PSI (or BAR) and Link icons, if Rcvr and TMT are active, ﬂashing when Link is lost

> Nx icon

> Full O2BG ﬂashing with O2 icon

> VARI while ascending

• A (< 2 sec) to access ALTs

• S (< 2 sec) to acknowledge alarms

• S (2 sec) to access Compass

• M (2 sec) to access Gas Switching

• L (closure) to activate Backlight

O2 Alarm Alt 1, information includes (Fig. 106) -

> Max Depth with MAX and FT (or M) icons

> Graphic EDT with Elapsed Dive Time (hr:min)

> Graphic FO2 with Set Point for Gas in use

> Graphic PO2 with current value (ATA)

> Nx icon

> TLBG with NI icon

• A (< 2 sec) to access ALT 2

• Revert to Main in 5 sec, if A not pressed

O2 Alarm Alt 2, information includes (Fig. 107) -

> Time of Day (hr:min sec), with A (or P) if 12 Hour

> Temperature with ° icon and graphic F (or C)

• 5 sec or A (< 2 sec), revert to Main

High O2 during Deco

If a High O2 Warning (80%) occurs while at a Deco Stop, the graphic O2 will ﬂash (in place of Stop Depth/Time) until the

Audible is silent, then Stop Depth/Time is restored.

If a High O2 Alarm (100%) strikes while at a Deco Stop, the graphic O2 and O2BG will ﬂash (in place of Stop Depth/Time

and TLBG) until on the surface. The Up Arrow icon will replace the Deco Stop icon (both arrows with bar) and ﬂash until on the

surface.

Fig. 103 - PO2 ALARM ALT 2

Fig. 104 - HIGH O2 (80%)

WARNING (during Audible)

Fig. 105 - HIGH O2 (100%)

ALARM MAIN

Fig. 106 - O2 ALARM ALT 1

Fig. 107 - O2 ALARM ALT 2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oceanic OC1 Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Oceanic OC1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info