Bedienungsanleitung OK OWM 5212 D (Seite 25 von 30) (Deutsch, Englisch)

783122

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

CHILD PROTECTION

10 Once the child protection is activated, the settings cannot be changed. The

washing machine can only be switched o with the program selector turned

to o (AUS / STOPP), whereby settings and wash progress are saved and the

washing process can be continued after switching the machine back on. The child

protection can only be activated if the washing machine operation was started or

is running either directly or by time delay.

1. Activation: Press the Startzeitverzögerung und Funktion buttons at once for

at least 3 seconds until an audible signal sounds 3 times. The corresponding

symbol of the control panel indicates the child protection .

2. De-activation: Press the Startzeitverzögerung und Funktion buttons again

at once for at least 3 seconds until an audible signal sounds 3 times. The

corresponding symbol of the control panel turns o.

CLEANING AND CARE

Warning

• When cleaning, never use solvents or abrasive materials, hard brushes, metallic or

sharp objects. Solvents are harmful to human health and can attack plastic parts,

while abrasive cleaning mechanisms and tools may scratch the surface(s).

• Switch o the washing machine and let it cool down completely before cleaning.

• Clean the exterior surfaces of the product with a slightly damp cloth and dry them

well. Make sure that no water enters the product interior (e.g. at the buttons).

11 Cleaning the detergent box

• Press the tab and lift up the detergent box.

• Wash the chambers with water.

• If necessary, use a soft brush to clean the housing.

• Dry it with a soft cloth and re-insert the detergent box.

12 Cleaning the ﬁlter of the lye pump

Caution

• Never operate the washing machine without a ﬁlter.

• The ﬁlter of the lye pump prevents foreign objects from entering and

possibly damaging the pumping system.

• Clean the ﬁlter regularly depending on the frequency of use,

approximately once a month.

• Check the ﬁlter if the water is not pumped out or if the noise is increased

during pumping.

• Before opening the service ﬂap, place a big cloth in front and below the

ﬂap. Large amounts of water may leak when removing the ﬁlter.

• Make sure that all water has been pumped out during the previous wash cycle,

then turn o the product and unplug the power cord.

• Place a big piece of cloth and a collecting tray in front of the service ﬂap to catch

any leaking water.

• Open the maintenance ﬂap.

• Turn the ﬁlter cover to the left. Catch leaking water!

• Clean the ﬁlter under running water and remove any foreign objects.

• Insert the ﬁlter and turn it to the right. Make sure that the ﬁlter is properly

fastened so that no water can leak.

• Close the maintenance ﬂap.

IM_OWM 5212 D_A5_DE_EN_210218_V04_HR.indb 25IM_OWM 5212 D_A5_DE_EN_210218_V04_HR.indb 25 18/2/2021 3:49 PM18/2/2021 3:49 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

OK OWM 5212 D Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info