Bedienungsanleitung Olsberg Turia Lina Compact (Seite 13 von 44) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

707624

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Regulations to be observed

● Local and building law regulations

● The stove must be installed by a professional and

connected to the chimney. The specic national reg-

ulations for safe installation of the connector must be

complied with. The connecting piece used must pos-

sess an opening for cleaning.

● The stove must be regularly checked by a profes-

sional.

● The stove has national technical approval from the

Deutsches Institut für Bautechnik (DIBt) (German

Institute for Civil Engineering) for room-air independ-

ent operation.

Due to its general technical approval, the stove

Turia Lina Compact can be used simultaneously

with an approved ventilation system without addi-

tional safety device.

The heating stove’s re door is self-closing; it is there-

fore approved for connection to chimneys with multiple

connections.

Chimney design

The chimney design is according to DIN EN 13384 - 2

or to the specic national regulations.

The chimney must comply with the temperature class

T400.

Necessary data

Closed operation:

● Nominal thermal output ................................. 5,0 kW

● Waste air mass ow rate ............................. 4,66 g/s

● Waste air temperature ................................... 367 °C

● Minimum delivery pressure at

nominal thermal output .................................... 12 Pa

Combustion air supply

The Turia Lina Compact stove can be operated con-

ventionally, dependent on the ambient air as well as in-

dependent of the ambient air.

It must be guaranteed that there is enough combustion

air available for the stove. For the proper function of the

stove, a necessary combustion air volume current of

15,6 m³/h must be considered.

Ambient air independent

combustion air connection

By an ambient air independent operating mode, the

combustion air must be added from outside through a

leak-proof line or through a supply duct in the chimney.

Thus, speak with your district chimney sweep master.

Due to energy saving reasons, the combustion air in-

let should be able to be blocked if the stove is not being

operated. This can occur through a shut-off valve in the

combustion air line or through the air slide valves on

the stove. If a shut-off valve is used, this must be clear-

ly identied with CLOSED/OPEN.

Through the shutoff, it is avoided that heat is removed

from the set-up room through the constant circulation

of cold combustion air and cold combustion air lines

may lead to an increased formation of condensation.

Attention:

The combustion air line may not be closed during

operation!

In order to feed the combustion air to the stove exter-

nally via a pipe instead of from the room in which it is in-

stalled, it is possible to screw a Ø 125 mm combustion

air pipe to the back of the stove or at the bottom. If the

combustion air pipe installed is longer than 3 m, calcu-

lations will have to be carried out to verify an adequate

supply of combustion air. At extremely low outdoor tem-

peratures, condensation can occur on the combustion

air duct. For this reason it must be insulated with a suit-

able insulating material. Observe the rules of the oven

and air heating construction craft.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olsberg Turia Lina Compact Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info