Bedienungsanleitung Olympus FC-1 Macro Flash System (Seite 4 von 53) (Englisch)

589209

Zoom out

Zoom in

Vorherige Seite

1/53

Nächste Seite

4 5

Note on the cameras used with the Macro Flash System

● The functions available from the Macro Flash System are limited with certain digital cameras. For details, please check

the Olympus website (http://www.olympusamerica.com/E1).

Before reading this manual

○ The information in this manual may be subject to change without notice.

○ This manual has been compiled as carefully as possible. However, if you have any questions or wish to report an error

or omission, please contact Olympus.

○ Duplication of this manual in part or in whole without permission of Olympus is prohibited except for personal use.

Reproduction of the contents of this manual without permission of Olympus is strictly prohibited.

○ Olympus will not assume any liability for damages, loss of profit or claims from any third party incurred due to improper

use of this product.

○ Olympus will not assume any liability for damages and loss of profit related to the loss of image data due to a failure of

this product, servicing by a third party not designated by Olympus, or any other reason.

○ Note that the quality of pictures shot with this product differs from the quality of pictures taken with ordinary film-based

cameras.

Trademark information

All brand names and product names mentioned in this manual are the trademarks or registered trademarks of their respec-

tive owners.

HANDLING PRECAUTIONS

 The Macro Flash System is composed of precision electronic parts. Absolutely avoid using or storing the

Macro Flash System in the following places, as this may result in malfunction or failure.

• Under direct sunlight, on a beach, etc.

• Anywhere exposed to high temperature and humidity or rapid fluctuations in temperature and humidity.

• Any place exposed to excessive sand, dust or dirt.

• Near a fire.

• Near an air conditioner or air humidifier.

• Any place exposed to water or moisture.

• Any place subject to vibrations.

• Inside an automobile.

 Do not apply a strong vibration or shock to the Macro Flash System by dropping it or hitting it against

something.

 When the Macro Flash System has not been used for a long period, mold or moss may form. This can cause

a malfunction. To prevent this, it is recommended to check the operations before using the Macro Flash

System after a long period of storage.

 Do not touch the electric contacts of the Macro Flash System to prevent malfunction.

 To prevent overheating and deterioration of the light-emitting section, do not continue full activation more than

40 times in a row. After firing the flash 40 times successively, do not use the flash for at least 10 minutes to

allow the light-emitting section to cool down.

BATTERY PRECAUTIONS

 Use only the specified batteries.

• AA (R6) alkaline dry cell batteries (LR6 type) ..................... x 4

• AA (R6) Ni-Cd batteries ...................................................... x 4

• AA (R6) Ni-Mh batteries ..................................................... x 4

• AA (R6) Ni-Mn batteries (ZR6 type) ................................... x 4

• AA (R6) lithium batteries (FR6 type) ................................... x 4

• Lithium battery packs (CR-V3 type) (Olympus LB-01) ....... x 2

* AA (R6) manganese batteries cannot be used.

 Be sure to observe the following points. Otherwise, battery fluid leak, overheating, fire ignition and/or bursting

may result.

• Do not mix old and new batteries, recharged and discharged batteries, batteries of different capacities, or

batteries of different types or brands.

• Do not attempt to recharge non-rechargeable batteries such as alkaline batteries.

• Do not load or use the batteries with the +/– polarity reversed. If the batteries do not fit smoothly in the battery

compartment, do not force them.

• Never use a battery if its outer coating (insulation) has been partially or entirely peeled off. Otherwise, leak-

age, overheating or explosion may result.

• Some brand-new batteries may also have their outer coating (insulation) peeled off completely or partially.

Never use these batteries.

 Do not use the following kinds of batteries.

 All rechargeable batteries must be recharged using the specified battery charger, simultaneously and com-

pletely. Be sure to read the battery and battery charger instruction manual.

 Improper use of batteries may result in fluid leak, heat generation and/or damage. Sweat and oil smudges

may cause battery contact failure. To prevent this, remove any stain completely with a dry cloth and insert the

batteries by observing the +/– polarity.

 In general, battery performance will be temporarily reduced as the ambient temperature drops. When using

batteries in a cold place, keep them warm by keeping the Macro Flash System in cold protection gear or

clothing.

 If battery fluid gets on your skin or clothes, it may irritate your skin. Immediately rinse your skin or clothes with

clean water.

 If battery fluid comes in contact with your eyes, blindness may result. Rinse your eyes with clean water without

rubbing them and see a doctor immediately.

 Do not apply a strong shock to a battery or throw it.

 When traveling, it is a good idea to carry spare batteries with you. In some countries, it may be difficult to

obtain certain batteries.

 Do not immerse batteries in water or moisten the terminals at its both ends.

 If the +/– terminals of a battery are stained with sweat or oil smudges, contact failure may result.

Clean the terminals well with a dry cloth before using the batteries.

 Do not throw a battery in fire or heat it.

 When disposing of batteries, be sure to follow local regulations.

 When disposing of a rechargeable battery, insulate the +/– terminals with pieces of tape and take them to your

nearest rechargeable battery recycling center.

Outer coating (insu-

lation) is peeling or

has peeled off.

The negative end is

slightly swollen and

is not covered by the

coating (insulation).

The negative end is

flat (whether or not a

part of the negative

pole is covered by

the coating).

Olympus FC-1 Macro Flash System Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info