CHANNEL UP/DOWN SIMULATION
If your original remote control did not have channel up/down keys, it is
possible to program the Topline 5 to operate this feature. By following the
instructions below, you will be able to use the Channel+/- keys on the
Topline 5 to advance though channels 0 through 9.
To turn on the Channel +/- Simulation feature:
Press and hold MAGIC until the display reads [TIMED
SEQ].
Press the Menu- key twice until the display changes to
[CONFIGURE]. Press ENTER and the display will change to
[TIME SETUP].
Press the Menu+ key one time until the display changes
to [CH +/- SIM]. Press ENTER and the display will read
[DISABLE].
Press Menu- one time to change the display to [ENABLE]
then press ENTER.
CLEAR ALL
If you would like to reset the Topline 5 of all advanced functions, you can
use the CLEAR ALL feature. The CLEAR ALL feature will clear the following
entries you have programmed for: SEQUENCES, TIMED SEQUENCES, VOLUME
LOCK, CH +/- SIMULATION and KEY MAGIC. CLEAR ALL will not erase your
set-up codes.
To clear the memory using the CLEAR ALL feature:
Press and hold MAGIC until the display reads [TIMED
SEQ].
Press the MENU- key twice until the display changes to
[CONFIGURE]. Press ENTER and the display will change to
[TIME SETUP].
Press the MENU+ key three times until the display
changes to [CLEAR ALL]. Press ENTER and the display will
read [CLR ALL].
Press ENTER and the display will read [CONFIRM]. Press
ENTER one more time and the display will return to the
main screen. The Topline 5 is now reset.
24
x 2
Advanced Functions
Note: To reset the Topline 5 back to the original channel +/- operation,
repeat steps 1-4 above. During step 4, use the Menu- to choose [DISABLE],
then press ENTER.
2
3
4
1
