Bedienungsanleitung OneTouch Ultra Easy (Seite 18 von 32) (Englisch)

685548

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

TESTING YOUR BLOOD GLUCOSE

 CAUTION: Dehydration and low glucose results

Severe dehydration resulting from excessive water loss may cause false low results. If you think you are suering from severe

dehydration, contact your healthcare professional immediately.

 CAUTION: Low glucose results

If your test result is lower than 3.9 mmol/L or is shown as LO, it may mean hypoglycaemia (low blood glucose). This may

require immediate treatment according to your healthcare professional’s recommendations. Although this result could be

due to a test error, it is safer to treat rst, then do another test.

 CAUTION: High glucose results

If your test result is higher than 10.0 mmol/L, it may mean hyperglycaemia (high blood glucose). If you are uncertain about

this test result, consider re-testing. Your healthcare professional can work with you to determine what actions, if any, you

should take if your results are higher than 10.0 mmol/L.

If your meter displays HI, you may have a very high blood glucose level (severe hyperglycaemia) exceeding 33.3 mmol/L.

Re-check your glucose level. If the result is HI again, this may indicate a severe problem with your blood glucose control and

it is important you obtain and follow instructions from your healthcare professional without delay.

 CAUTION: Repeated unexpected glucose results

If you continue to get unexpected results, check your system with control solution. See Section 5, Control solution testing.

If you are experiencing symptoms that are not consistent with your blood glucose results and you have followed all

instructions in this User Guide, call your healthcare professional. Never ignore symptoms or make signicant changes to your

diabetes control programme without speaking to your healthcare professional.

 CAUTION: Unusual red blood cell count

A haematocrit (percentage of your blood that is red blood cells) that is either very high (above 55%) or very low (below 30%)

can cause false results.

After getting a result

Once you have read your result, you may:

• Review your meter memory by pressing ▼ to enter memory mode, see Section 4, Reviewing past results, or

• Turn the meter o by removing the test strip.

Removing the used lancet

Remove the lancing device cap by snapping it o. Cover the exposed lancet tip before removing

the lancet. Place the lancet protective disk on a hard surface. Push the lancet tip into the disk. Remove

the lancet and place it in a container for sharp objects. Replace the cap.

Disposing of the used lancet and test strip

It is important to discard the used lancet carefully after each use to avoid unintended lancet stick

injuries. Used test strips and lancets may be considered biohazardous waste in your area. Be sure to

follow your local regulations or your healthcare professional's recommendations for proper disposal.

Downloaded from www.Manualslib.com manuals search engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

OneTouch Ultra Easy Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von OneTouch Ultra Easy

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info