Bedienungsanleitung Onkyo cr 305 tx (Seite 4 von 36) (Englisch)

158316

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

■ 2 × 20 watts min RMS at 4 ohms, 1 kHz no more than

1.0 % THD (FTC rating)

■ 2 × 20 watts at 4 ohms, 1 kHz, DIN

■ 2 × 25 watts at 4 ohms, EIAJ

■ 4-Ohm Drive capability

■ High-Grade Discrete Outputs Stage Circuits

■ Brushed Aluminium Front Panel

■ 4-step Acoustic Presence control

■ Illuminated Volume knob

■ Optical Digital Output

■ Full-Function Remote Control

U.S. & Canadian models

■ Subwoofer Preout

■ CDR and Tape Inputs/Outputs

European and Asian models

■ Auto Digital Level Adjustment for Synchro-Recording

(When connected to MD-105X/TX or CDR-205X/TX)

■ MD, CDR, and Tape Inputs/Outputs

■ RDS (PS) (European models)

Features

For U.S. model

The laser is covered by a housing which prevents exposure during

operation or maintenance. However, this product is classified as a

Laser Product by CDRH (Center for Devices and Radiological Health)

which is a department of the Food and Drug Administration. Accord-

ing to their regulations 21 CFR section 1002.30, all manufactures

who sell Laser Products must maintain records of written communi-

cations between the manufacturer, dealers and customers concerning

radiation safety. If you have any complaints about instructions or

explanations affecting the use of this product, please feel free to write

to the address on the back page of this manual. When you write us,

please include the model number and serial number of your unit.

In compliance with Federal Regulations, the certification, identifi-

cation and the period of manufacture are indicated on the rear panel.

FCC Information for User

CAUTION:

The user changes or modifications not expressly approved by the

party responsible for compliance could void the user’s authority to

operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment gen-

erates, uses and can radiate radio frequency energy and, if not in-

stalled and used in accordance with the instructions, may cause harm-

ful interference to radio communications. However, there is no guar-

antee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or televi-

sion reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s atten-

tion to Section 820-40 of the NEC which provides guidelines for

proper grounding and, in particular, specifies that the cable ground

shall be connected to the grounding system of the building, as close

to the point of cable entry as practical.

For Canadian model

NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES

WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE

BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle pour les Canadien

REMARQUE: CET APPAREIL NUMÉRIQUE DE LA CLASSE

B EST CON-FORME À LA NORME NMB-003 DU CANADA.

Sur les modèles dont la fiche est polarisée:

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES,

INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS

LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER

JUSQU’AU FOND.

For British model

Replacement and mounting of an AC plug on the power supply cord

of this unit should be performed only by qualified service personnel.

IMPORTANT

The wires in the mains lead are coloured in accordance with the

following code:

Blue : Neutral

Brown : Live

As the colours of the wires in the mains lead of this apparatus may

not correspond with the coloured markings identifying the terminals

in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal

which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the termi-

nal which is marked with the letter L or coloured red.

Memory Preservation

This unit does not require memory preservation batteries. A built-

in memory power back-up system preserves the contents of the

memory during power failures and even when the unit is un-

plugged. The unit must be plugged in order to charge the back-up

system.

The memory preservation period after the unit has been unplugged

varies depending on climate and placement of the unit. On the

average, memory contents are protected over a period of a few

weeks after the last time the unit has been unplugged. This pe-

riod is shorter when the unit is exposed to a highly humid cli-

mate.

IMPORTANT

A 5 ampere fuse is fitted in this plug. Should the fuse need to be

replaced, please ensure that the replacement fuse has a rating of 5

amps and that it is approved by ASTA or BSI to BS1362. Check for

the ASTA mark or the BSI mark on the body of the fuse.

IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE

SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD

BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF

SAFELY. THERE IS A DANGER OF SEVERE ELECTRICAL

SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13

AMPERE SOCKET.

If in any doubt, please consult a qualified electrician.

Onkyo cr 305 tx Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info