Bedienungsanleitung Onkyo CS-245DAB (Seite 35 von 40) (Englisch)

492680

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

En-35

Troubleshooting

If you have any trouble using the CD receiver, look for a solution in this section.

Can’t turn on the CD receiver.

• Make sure that the power cord is properly plugged into the wall outlet (see page 16).

• Make sure that the power cord is properly plugged into the CD receiver’s AC INLET (see page 16).

• Unplug the power cord from the wall outlet, wait 30 minutes or more, then plug it in again.

The CD receiver turns off unexpectedly.

• If the sleep timer has been set and the SLEEP indicator is shown on the display, the CD receiver will turn off

automatically after a specified period (see page 33).

There’s no sound.

• Make sure the CD receiver’s volume is not set too low (see page 17).

• Make sure the correct input source is selected (see page 17).

• Make sure the CD receiver is not muted (see page 17).

• Check all connections and correct as necessary (see pages 14 to 16).

• While headphones are connected, the speakers output no sound (see page 17).

• If there’s no sound from an external device connected to LINE IN, check whether the external device’s audio output

level (volume) might be too low.

The sound quality is not good.

• Make sure the speaker cables are connected with the correct polarity (see page 14).

• Make sure all audio connecting plugs are pushed in all the way (see page 15).

• The sound quality can be affected by strong magnetic fields, such as that from a TV. Try moving any such devices

away from the CD receiver.

• If you have any devices that emit high-intensity radio waves near the CD receiver, such as a cellular phone that’s being

used to make a call, the CD receiver may output noise.

• The CD receiver’s precision drive mechanism may emit a faint hissing sound while reading discs during playback or

when searching for tracks. You may be able to hear this noise in extremely quiet environments.

Audio output is intermittent when the CD receiver is subjected to vibration.

• The CD receiver is not a portable device. Use it in a location that’s not subject to shock or vibration.

• Make sure that the included cork floor pads are attached to the speakers (see page 11).

Headphones output is intermittent or there’s no sound.

• This may be due to dirty contacts. Clean the headphones plug. See your headphones’ instruction manual for cleaning

information. Also, make sure that the headphones cable is not broken or damaged.

Audio performance.

• Audio performance will be at its best about 10 to 30 minutes after the CD receiver has been turned on and had time

to warm up.

• Using cable ties to bundle audio cables with speaker or power cables may degrade the sound quality, so don’t do it.

Power

Audio

If you can’t resolve the issue yourself, try resetting the CD receiver before

contacting your Onkyo dealer.

To reset the receiver to its factory defaults, turn it on and, while holding down

the CD receiver’s stop [] button, press the [ ON/STANDBY] button.

When the display indicates “RESET,” release the buttons. After a while, the

CD receiver will enter standby mode.

Note that resetting the CD receiver will delete your radio presets and custom settings.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo CS-245DAB Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo CS-245DAB

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info