Bedienungsanleitung Onkyo TA-RW255 (Seite 3 von 16) (Englisch)

608265

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Precautions

1. Recording Copyright

—Unless it’s for personal use only,

recording copyrighted material is illegal without the permis-

sion of the copyright holder.

AC Fuse

—The AC fuse inside the unit is not user-serviceable.

If you cannot turn on the unit, contact your Onkyo dealer.

Care

—Occasionally you should dust the unit all over with a

soft cloth. For stubborn stains, use a soft cloth dampened with

a weak solution of mild detergent and water. Dry the unit

immediately afterwards with a clean cloth. Don’t use abrasive

cloths, thinners, alcohol, or other chemical solvents, because

they may damage the ﬁnish or remove the panel lettering.

4. Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST

TIME, READ THE FOLLOWING SECTION CAREFULLY.

AC outlet voltages vary from country to country. Make sure

that the voltage in your area meets the voltage requirements

printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC

120 V, 60 Hz).

Setting the [STANDBY/ON] switch to STANDBY does not

fully shutdown the unit. If you do not intend to use the unit for

an extended period, remove the power cord from the AC outlet.

5. Never Touch this Unit with Wet Hands—

Never handle this

unit or its power cord while your hands are wet or damp. If

water or any other liquid gets inside this unit, have it checked

by your Onkyo dealer.

6. Handling Notes

• If you need to transport this unit, use the original packag-

ing to pack it how it was when you originally bought it.

• Do not leave rubber or plastic items on this unit for a long

time, because they may leave marks on the case.

• This unit’s top and rear panels may get warm after pro-

longed use. This is normal.

• If you do not use this unit for a long time, it may not work

properly the next time you turn it on, so be sure to use it

occasionally.

• When you’ve ﬁnished using this unit, remove cassettes and

turn off the power.

7. Deck Location

• Do not use or leave in direct sunlight or in other places

subject to high temperature and humidity. The unit should

also not be left in potentially hot places such as near heat-

ing appliances. Excessive heat and moisture can lead to

internal damage and serious malfunctions (this also applies

to cassette tapes). The recommended ambient temperature

range is 5°C to 35°C.

•Avoid damp and dusty places and locations prone to vibra-

tions.

• Be extremely careful with the recording/playback heads.

Clean and demagnetize them regularly, but under no cir-

cumstances should magnets or other metals be used any-

where near the heads.

• This unit is extremely sensitive to magnetic ﬁelds, so do

not use near large speakers or other devices which generate

magnetic ﬁelds.

• Hum may even be induced by magnetic ﬂux leakage from

the power transformer in certain ampliﬁers. Therefore, this

unit should also be kept clear of the ampliﬁer.

• Do not remove the cabinet case. If any of the internal parts

are handled, there is a considerable danger of electric shock.

8. Cassettes to Avoid:

• Cassettes with poorly formed cases that rattle during

rewind and fast forward.

•Low cost cassettes with no guide roller or pressure pad

spring should never be used for stereo.

• C-100–120 cassettes because the tape and the coating are

extremely thin, distortion levels are high. Also, even a

slight stretching of the tape will make it susceptible to

being caught up in the pinch roller and capstan.

• Endless tapes, if used for a long period of time, can over-

heat.

9. Moisture Condensation

Moisture condensation may damage this unit.

Read the following carefully:

• Moisture condensation can occur in the following situa-

tions:

– The unit is moved from a cold place to a warm place.

–A heater is turned on, or cold air from an air conditioner

is hitting the unit.

– In the summer, when this unit is moved from an air con-

ditioned room to a hot and humid place.

– The unit is used in a humid place.

• Do not use this unit when there’s the possibility of mois-

ture condensation occurring. Doing so may damage your

cassettes and certain parts inside this unit.

If condensation does occur, remove all cassettes and leave this

unit turned on for two to three hours. By this time, the unit will

have warmed up and any condensation will have evaporated.

For British models

Replacement and mounting of an AC plug on the power supply

cord of this unit should be performed only by qualiﬁed service

personnel.

IMPORTANT

The wires in the mains lead are coloured in accordance with the

following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this apparatus

may not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the termi-

nal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the ter-

minal which is marked with the letter L or coloured red.

IMPORTANT

The plug is ﬁtted with an appropriate fuse. If the fuse needs to be

replaced, the replacement fuse must approved by ASTA or BSI to

BS1362 and have the same ampere rating as that indicated on the

plug. Check for the ASTA mark or the BSI mark on the body of

the fuse.

If the power cord’s plug is not suitable for your socket outlets, cut

it off and ﬁt a suitable plug. Fit a suitable fuse in the plug.

For Canadian Models

For models having a power cord with a polarized plug:

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH

WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

TA-RW255_En.book Page 3 Tuesday, April 19, 2005 4:36 PM

Onkyo TA-RW255 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info