Bedienungsanleitung Onkyo TX-L55 (Seite 61 von 63) (Englisch)

645294

Zoom out

Zoom in

Vorherige Seite

1/63

Nächste Seite

Troubleshooting

—Continued

• Make sure that the TX-L55 is not subjected to direct

sunshine or inverter-type ﬂuorescent lights. Relocate

if necessary.

• If the TX-L55 is installed in a rack or cabinet with col-

ored-glass doors, the remote controller may not work

reliably when the doors are closed.

• Make sure you’ve selected the correct remote control-

ler mode (page 11).

• When using the remote controller to control other

manufacturers’ AV components, some buttons may

not work as expected.

• Make sure you’ve entered the correct remote control

code.

Can’t control other components?

• If it’s an Onkyo DVD player, make sure that the

cable and analog audio cable (RCA) are connected

properly. Connecting only an cable won’t work

(page 29).

• Make sure you’ve selected the correct remote control-

ler mode (pages 11, 12, and 14).

Can’t record?

• On your recorder, make sure the correct input is

selected.

• Digital signals cannot be recorded.

The sound changes when I connect my head-

phones?

• When a pair of headphones is connected, the listening

mode is set to Stereo, unless it’s already Stereo or

Direct. When you disconnect the headphones, the pre-

vious listening mode is resumed.

Can’t use an audio adjust function?

• Some audio adjust functions can’t be used with certain

listening modes.

The speaker distance cannot be set as

required?

• If the distance between the furthest and nearest speak-

ers is greater than 20 feet (6 meters), corrected values

suitable for home theater use will be set automatically

(page 50).

Recording

Others

The TX-L55 contains a microcomputer for signal pro-

cessing and control functions. In very rare situations,

severe interference, noise from an external source, or

static electricity may cause it to lockup. In the unlikely

event that this happens, unplug the power cord from the

wall outlet, wait at least ﬁve seconds, and then plug it

back in again.

To reset the TX-L55 to its factory defaults, turn it on and,

while holding down the [ ] TUNING button, press the

[STANDBY/ON] button. When the reset is complete,

“Clear” appears on the display and the TX-L55 enters

Standby mode.

Onkyo cannot be held responsible for damages (such

as CD rental fees) due to recording failures caused by

the unit malfunctioning. Before recording something

important, do a trial run to make sure that everything is

working properly.

Memory backup

The TX-L55 uses a battery-less memory backup sys-

tem in order to retain radio presets and other settings

when it’s unplugged or in the case of a power failure.

Although no batteries are required, it must be plugged

into an AC outlet in order to charge the backup system.

Once it has been charged, the TX-L55 will retain the

settings for several weeks, although this depends on

the environment and will be shorter in humid climates.

TX-L55_En.book Page 61 Tuesday, June 1, 2004 9:02 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-L55 Seite 61

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info