492661
44
Zoom out
Zoom in
Vorherige Seite
1/168
Nächste Seite
Turning On & Basic Operations
En-44
Note
You can cancel Audyssey MultEQ XT32 Room Correction and
Speaker Setup at any point in this procedure simply by
disconnecting the setup microphone.
Do not connect or disconnect any speakers during
Audyssey MultEQ XT32 Room Correction and Speaker Setup.
If the AV receiver is muted, it will be unmuted automatically
when Audyssey MultEQ XT32 Room Correction and Speaker
Setup starts.
Changes to the room after Audyssey MultEQ XT32 Room
Correction and Speaker Setup requires you run
Audyssey MultEQ XT32 Room Correction and Speaker Setup
again, as room EQ characteristics may have changed.
Error Messages
While Audyssey MultEQ XT32 Room Correction and
Speaker Setup is in progress, one of the error messages
below may appear.
The options are:
` Retry:
Try again.
` Cancel:
Cancel Audyssey MultEQ XT32 Room Correction
and Speaker Setup.
Ambient noise is too high.
The background noise is too loud. Remove the source of
the noise and try again.
Speaker Matching Error!
The number of speakers detected was different from that
of the first measurement. Check the speaker connection.
Writing Error!
This message appears if saving fails. Try saving again. If
this message appears after 2 or 3 attempts, contact your
Onkyo dealer.
Speaker Detect Error
This message appears if a speaker is not detected.No
means that no speaker was detected.
Tip
See “Speaker Configuration” for appropriate settings
( page 13).
9
Use q/w to select an option, and then press ENTER.
The options are:
` Save:
Save the calculated settings and exit
Audyssey MultEQ
®
XT32 Room Correction and
Speaker Setup.
` Cancel:
Cancel Audyssey MultEQ XT32 Room
Correction and Speaker Setup.
Tip
You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels by
using e/r.
Save
Cancel
MultEQ XT32: Auto Setup
AUDYSSEY
-- Review Speaker Configuration --
2ch
40Hz
40Hz
100Hz
None
100Hz
120Hz
2ch
Subwoofer
Front
Center
Surround
Front Wide
Front High
Surround Back
Surround Back Ch
10
Use q/w to select a target, and use e/r to change
the setting.
After the results of Audyssey MultEQ XT32 have
been saved, the menu will display the “Audyssey”
( page 76), “Dynamic EQ” ( page 76),
“Dynamic Volume” ( page 76) settings.
Note
•WhenAudyssey Quick Start” has been used for
measurement, “Audyssey” cannot be selected.
These settings are applied to all input selectors.
11
Press ENTER.
12
Disconnect the speaker setup microphone.
Retry
Cancel
Ambient noise is too high.
AUDYSSEY
MultEQ XT32: Auto Setup
Error message
44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo TX-NR3010 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Onkyo TX-NR3010

Onkyo TX-NR3010 Bedienungsanleitung - Deutsch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Holländisch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Französisch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Italienisch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Spanisch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Schwedisch - 168 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info