492661
111
Zoom out
Zoom in
Vorherige Seite
1/168
Nächste Seite
Appendix
En-111
Connection Tips and
Video Signal Path
The AV receiver supports several connection formats for
compatibility with a wide range of AV equipment. The
format you choose will depend on the formats supported by
your components. Use the following sections as a guide.
Video components can be connected by using any one of
the following video connection formats: composite video,
PC IN (Analog RGB), component video, or HDMI, the
latter offering the best picture quality.
The AV receiver can upconvert between video formats,
depending on the “Monitor Out” setting ( page 63),
which generally determines whether video signals are
upconverted for the component video output or the HDMI
output.
Tip
For optimal video performance, THX recommends that video
signals pass through the system without upconversion (e.g.,
component video input passing through to component video
output).
To by-pass the upconversion, set the Picture Mode” setting to
Direct” ( page 78).
“Monitor Out” set to “HDMI Main” or “HDMI
Sub”
Video input signals flow through the AV receiver as
shown, with composite video, PC IN (Analog RGB), and
component video sources all being upconverted for the
HDMI output. Use these settings if you connect either
HDMI OUT MAIN or HDMI OUT SUB of the AV
receiver to your TV.
The composite video and component video outputs pass
through their respective input signals as they are.
When you connect a video component to an HDMI or
COMPONENT, you must assign that input to an input
selector ( pages 64, 65).
“Monitor Out” set to “Both”
Video input signals flow through the AV receiver as
shown, with composite video, PC IN (Analog RGB), and
component video sources all being upconverted for both
HDMI outputs. Use this setting if you connect both
HDMI OUT MAIN and HDMI OUT SUB of the AV
receiver to your TV.
Note that video signals are output from both HDMI outputs
at the resolution supported by both TVs.
The composite video and component video outputs pass
through their respective input signals as they are.
When you connect a video component to an HDMI or
COMPONENT, you must assign that input to an input
selector ( pages 64, 65).
Note
When “Monitor Out” is set to “Both”, the “Resolution” setting
cannot be selected ( page 63).
The on-screen setup menus appear only on a TV that
is connected to HDMI OUT MAIN. If your TV is
connected to other video outputs, use the AV
receiver’s display when changing settings.
Video Connection Formats
IN
MONITOR OUT
Blu-ray Disc/DVD player, etc.
AV receiver
TV, projector, etc.
Composite
Composite
Component
Component
Video Signal Flow Chart
HDMIPC IN
(Analog RGB)
HDMI
IN
MONITOR OUT
Blu-ray Disc/DVD player, etc.
AV receiver
TV, projector, etc.
Composite
Composite
Component
Component
Video Signal Flow Chart
HDMI
HDMI
PC IN
(Analog RGB)
111

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo TX-NR3010 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Onkyo TX-NR3010

Onkyo TX-NR3010 Bedienungsanleitung - Deutsch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Holländisch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Französisch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Italienisch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Spanisch - 168 seiten

Onkyo TX-NR3010 Bedienungsanleitung - Schwedisch - 168 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info