553769
7
Zoom out
Zoom in
Vorherige Seite
1/97
Nächste Seite
7
Before Using the TX-NR801/TX-NR801E
The worldwide model has a voltage selector for com-
patibility with power systems around the world. Before
you plug in this model, make sure that the voltage selec-
tor is set to the correct voltage for your area. If it isn’t,
use a small screwdriver to set it appropriately. For
example, if the voltage in your area is 120 volts (V), set
the selector to “120V.And if it’s between 220 and 230
volts (V), set it to “220-230V.
Notes:
The supplied batteries should last for about six
months, although this will vary with usage.
If the remote controller doesn’t work reliably, try
replacing both batteries.
Don’t mix new and old batteries, or different types of
batteries.
If you intend not to use the remote controller for a
long time, remove the batteries to prevent possible
leakage and corrosion.
Dead batteries should be removed as soon as possible
to prevent possible leakage and corrosion.
To use the remote controller, point it at the TX-NR801/
TX-NR801E’s remote control sensor, as shown below.
The TX-NR801/TX-NR801E’s STANDBY indicator
flashes while a signal is being received from the remote
controller.
Notes:
The remote controller may not work reliably if the
TX-NR801/TX-NR801E is subjected to bright light,
such as direct sunlight or inverter-type fluorescent
lights. Keep this in mind when installing the
TX-NR801/TX-NR801E.
If another remote controller of the same type is used
in the same room, or the TX-NR801/TX-NR801E is
installed close to equipment that uses infrared rays,
the remote controller may not work reliably.
Don’t put anything, such as a book, on the remote
controller, because the buttons may be pressed inad-
vertently, thereby draining the batteries.
The remote controller may not work reliably if the
TX-NR801/TX-NR801E is installed in a rack behind
colored glass doors. Keep this in mind when install-
ing the TX-NR801/TX-NR801E.
The remote controller will not work if there’s an
obstacle between it and the TX-NR801/
TX-NR801E’s remote control sensor.
Setting the Voltage Selector
(Worldwide model only)
Installing the Batteries
1
Remove the battery compartment cover
by pressing it and sliding it in the direc-
tion shown by the arrow below.
2
Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3
After the batteries are installed and
seated correctly, replace the compart-
ment cover .
SURR
BACK/
ZONE 2
SPEAKERS
AUDIO
VIDEO
S VIDEO
MONITOR
OUT
R
L
IN
IN
IN
IN
IN
ZONE 2
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO
VIDEO
S VIDEO
COMPONENT
VIDEO
Y
P
B
PR
OUTPUT
INPUT 1
Y
P
B
PR
INPUT 2
Y
P
B
PR
FRONT SPEAKERS
L
RL
R
SURR SPEAKERS
CENTER
SPEAKER
R
L
R
L
OUT
OUT
OUT
I
R
IN
OUT
REMOTE
CONTROL
PHONO
DIGITAL
IN
PRE OUT
DIGITAL
OUT
OPT
OPT
2
1
2
1
2
3
FRONT
SUB
SURR
R
L
AUDIO
R
L
CD
TAPE
R
L
AUDIO
1
3
GND
SURR
BACK/
ZONE 2
IN
OUT
COAX
R
L
MULTI
CH
INPUT
FRONT
SUB
SURR
SURR
BACK
CENTER
R
L
R
L
AM
FM
75
CENTER
ANTENNA
IN
IN
(
Net
-
Tune
)
ETHERNET
4 OHMS MIN. OR
6 OHMS MIN.
/SPEAKER
CAUTION
:
SPEAKER
IMPEDANCE
SEE INSTRUCTION
MANUAL FOR
CORRECT SETTINGS.
AV RECEIVER
MODEL NO. TX
-
NR
801
VOLTAGE
SELECTOR
220
-
230V
120V
AC
OUTLETS
AC 230
-
240
V 50
Hz
SWITCHED
TOTAL 100
W MAX.
120V
VOLTAGE
SELECTOR
220-230V
Using the Remote Controller
30˚
30˚
Approx. 16 ft. (5 m)
Remote control sensor
Standby indicator
TX-NR801/TX-NR801E
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo TX-NR801 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info