Bedienungsanleitung Onkyo TX-NR807 (Seite 107 von 148) (Englisch)

553771

107

Zoom out

Zoom in

Vorherige Seite

1/148

Nächste Seite

107

NET

The AV receiver is network-ready, which means you can

hook it up to your home network with a standard Ether-

net cable and enjoy the music files stored on your com-

puter or media server. If your network is connected to the

Internet, you can also enjoy Internet radio.

Network Requirements

■ Ethernet Network

The AV receiver’s Ethernet port supports 10Base-T. For

best results, a 100Base-TX switched Ethernet network is

recommended. Although it’s possible to play music on a

computer that’s connected to the network wirelessly,

playback may be unreliable, so wired connections are

recommended.

■ Ethernet Router

A router manages the network, routing data and supply-

ing IP addresses. Your router must support the following:

• NAT (Network Address Translation). NAT allows sev-

eral networked computers to access the Internet simul-

taneously via a single Internet connection. The

AV receiver needs Internet access for Internet radio.

• DHCP (Dynamic Host Configuration Protocol).

DHCP supplies IP addresses to network devices,

allowing them to configure themselves automatically.

• A router with a 100Base-TX switch built-in is recom-

mended.

Some routers have a modem built-in, and some ISPs

require you to use specific routers. Please consult your

ISP or computer dealer if you’re unsure.

■ CAT5 Ethernet cable

Use a shielded CAT5 Ethernet cable (straight-type) to

connect the AV receiver to your home network.

■ Internet Access (for Internet radio)

To receive Internet radio, your Ethernet network must

have Internet access. A narrowband Internet connection

(e.g., 56K modem, ISDN) will not provide satisfactory

results, so a broadband connection is strongly recom-

mended (e.g., cable modem, xDSL modem, etc). Please

consult your ISP or computer dealer if you’re unsure.

Notes:

• To receive Internet radio with the AV receiver, your

broadband Internet connection must be working and

able to access the Web. Consult your ISP if you have

any problems with your Internet connection.

• The AV receiver uses DHCP to configure its network

settings automatically. If you want to configure these

settings manually, see page 113.

• The AV receiver does not support PPPoE settings, so

if you have a PPPoE-type Internet connection, you

must use a PPPoE-compatible router.

• Depending on your ISP, you may need to specify a

proxy server to use Internet radio. If your computer is

configured to use a proxy server, use the same settings

for the AV receiver (see page 113).

To connect the AV receiver to your home network, plug

one end of a shielded CAT5 Ethernet cable into the

AV receiver’s ETHERNET port, and plug the other end

into a LAN port on your router or switch.

The following diagram shows how you can connect the

AV receiver to your home network. In this example, it’s

connected to a LAN port on a router, which has a 4-port

100Base-TX switch built-in.

About NET

Connecting the AV Receiver

ETHERNET

Internet radio

Modem

Router

Computer or media server

LAN/Ethernet port

WAN port

LAN port

TX-NR807_En.book Page 107 Tuesday, July 28, 2009 12:00 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR807 Seite 107

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR807

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info