Bedienungsanleitung Onkyo TX-NR828 (Seite 77 von 152) (Englisch)

527521

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

Advanced Operations

En-77

Operating

procedure

(➔ page 60)

Network

This section explains how to configure the AV

receiver’s network settings manually.

After modifying the network settings, you must

confirm the changes by executing “Save”.

If your router’s DHCP server is enabled, you don’t

need to change any of these settings, as the AV

receiver is set to use DHCP to configure itself

automatically by default (i.e., DHCP is set to

“Enable”). If, however, your router’s DHCP server is

disabled (you’re for example using static IP), you’ll

need to configure these settings yourself, in which

case, a knowledge of Ethernet networking is

essential.

What’s DHCP?

DHCP (Dynamic Host Configuration Protocol) is used

by routers, computers, the AV receiver, and other

devices to automatically configure themselves on a

network.

What’s DNS?

The DNS (Domain Name System) translates domain

names into IP addresses. For example, when you

enter a domain name such as www.onkyousa.com in

your Web browser, before accessing the site, your

browser uses DNS to translate this into an IP

address, in this case 63.148.251.142.

■ Network Connection

` Wired

` Wireless

This setting determines whether you connect the AV

receiver to network by wired LAN or wireless LAN. If

you connect by wireless LAN, select “Wireless”. See

“Performing Wireless LAN Setup” for setting

(➔ page 30).

Tip

• The same setting is available even if “Wireless” is selected

in “Network Connection” in initial setup (➔ page 26).

■ MAC Address

This is the AV receiver’s MAC (Media Access

Control) address. This address cannot be changed.

■ DHCP

` Enable

` Disable

This setting determines whether or not the AV

receiver uses DHCP to automatically configure its IP

Address, Subnet Mask, Gateway, and DNS Server

settings.

Note

• If you select “Disable”, you must configure the “IP

Address”, “Subnet Mask”, “Gateway”, and “DNS Server”

settings yourself.

■ IP Address

` Class A:

“10.0.0.0” to “10.255.255.255”

` Class B:

“172.16.0.0” to “172.31.255.255”

` Class C:

“192.168.0.0” to “192.168.255.255”

Enter a static IP address provided by your Internet

Service Provider (ISP).

Most routers use Class C IP addresses.

■ Subnet Mask

Enter the subnet mask address provided by your ISP

(typically 255.255.255.0).

■ Gateway

Enter the gateway address provided by your ISP.

■ DNS Server

Enter the DNS server address provided by your ISP.

■ Proxy URL

To use a Web proxy, enter its URL here.

■ Proxy Port

If you’re using a Web proxy, enter a proxy port

number here.

■ Network Standby

` On

` Off

This setting enables or disables control over the

network.

When enabled, the NET indicator will be dimly-lit

while the AV receiver is in standby mode. Note that

the indicator may not light under certain conditions

(➔ page 25).

Note

• When set to “On”, the power consumption slightly

increases in standby mode.

■ Update Notice

` Enable

` Disable

When this setting is enabled, you will be notified if a

firmware update via network of high importance is

available.

Note

• Selecting “Never Remind me” on the notification window

will switch this setting to “Disable” (➔ page 25).

• For details on the update notification, see “Firmware

Update Notification” (➔ page 25).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR828 Seite 77

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR828

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info