Bedienungsanleitung Onkyo TX-NR905 (Seite 133 von 136) (Englisch)

64580

133

Zoom out

Zoom in

Vorherige Seite

1/136

Nächste Seite

133

Troubleshooting

—Continued

There’s no picture from a source connected to

an HDMI IN

• When the HDMI Monitor setting is set to No, and the

Resolution setting is set to anything other than

Through (see page 52), no video is output by the

HDMI OUT.

• If the message “Resolution Error” appears on the AV

receiver’s display, this indicates that your TV does not

support the current video resolution and you need to

select another resolution on your DVD player.

The onscreen menus don’t appear

• On your TV, make sure that the video input to which

the AV receiver is connected is selected.

The picture is distorted

• On non-North American models, specify the TV sys-

tem used in your area in the “TV Format Setup” on

page 66.

Reception is noisy, stereo FM reception suffers

from hiss, or the FM STEREO indicator doesn’t

light up

• Relocate your antenna.

•Move the AV receiver away from your TV or com-

puter.

• Listen to the station in mono (page 69).

• When listening to an AM station, operating the remote

controller may cause noise.

•Passing cars and airplanes can cause interference.

• Concrete walls weaken radio signals.

• If nothing improves the reception, install an outdoor

antenna.

The remote controller doesn’t work

• Make sure that the batteries are installed with the cor-

rect polarity (page 15).

• Make sure that the remote controller is not too far

away from the AV receiver and there’s no obstruction

between the remote controller and the AV receiver’s

remote control sensor (page 15).

• Make sure you’ve selected the correct remote control-

ler mode (page 16).

• Make sure you’ve entered the correct remote control

code (page 126).

Can’t control other components

• Make sure you’ve selected the correct remote control-

ler mode (page 16).

• If you’ve connected an -capable Onkyo MD

recorder, CD recorder, or RI Dock to the TAPE

IN/OUT jacks, or an RI Dock to the GAME/TV IN

jacks, for the remote controller to work properly, you

must set the Input Display to MD, CDR, or DOCK,

respectively (see page 57).

• The entered remote control code may not be correct. If

more than one code is listed, try each one.

• If none of the codes work, use the Learning function

to learn the commands of the other component’s

remote controller (page 129).

•With some AV components, certain buttons may not

work as expected, and some may not work at all.

•To control an Onkyo component that’s connected via

, point the remote controller at the AV receiver. Be

sure to enter the appropriate remote control code ﬁrst

(page 127).

•To control an Onkyo component that’s not connected

via , or another manufacturer’s component, point

the remote controller at that component. Be sure to

enter the appropriate remote control code ﬁrst

(page 126).

Can’t learn commands from another remote

controller

• When learning commands, make sure that the trans-

mitting ends of both remote controllers are pointing at

each other.

• Are you trying to learn from a remote controller that

cannot be used for learning? Some commands cannot

be learned, especially those that contain several

instructions.

Can’t record

• On your recorder, make sure the correct input is

selected.

•To prevent signal loops and damage to the AV

receiver, input signals are not fed through to outputs

with the same name (e.g., TAPE IN to TAPE OUT or

VCR/DVR IN to VCR/DVR OUT).

• When the Pure Audio listening mode is selected, video

recording is not possible because no video signals are

output. Select another listening mode.

Tuner

Remote Controller

Recording

TX-NR905_En.book Page 133 Monday, June 18, 2007 12:55 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR905 Seite 133

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR905

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info