Bedienungsanleitung Panasonic AG-DVC 20p (Seite 34 von 42) (Englisch)

597929

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

Others

Functions cannot be used simultaneously

Some functions in the camera-recorder are disabled or cannot

be selected due to its specifications. The table below shows

examples of functions restricted by conditions.

Before requesting repair (Problems and

solutions)

Power/Body

1: The camera-recorder power cannot be turned on.

• Is the battery fully charged? Use a fully charged battery.

• The battery protection circuit may have operated. Attach the

battery to the AC adapter for 5 to 10 seconds. If the camera-

recorder still cannot be used, the battery is faulty.

2: The camera-recorder power is turned off automatically.

• If you set [POWER SAVE] to [5 MINUTES] and do not

operate the camera-recorder for about 5 continuous minutes,

the power is automatically turned off for tape protection and

power conservation. To resume recording, turn the [OFF/ON]

switch to [OFF]. Then turn it to [ON] again. (

-32-)

3: The camera-recorder power does not stay on long

enough.

• Is the battery low? If the remaining battery power indication is

flashing or the message “LOW BATTERY” is displayed, the

battery has run down. Charge the battery or attach a fully

charged battery. (

-10-)

• Has condensation occurred? When you carry the camera-

recorder from a cold place into a warm place, condensation

may occur inside it. If so, the power is turned off

automatically, disabling all operations except for taking

cassettes out. Wait until the condensation indication

disappears. (

-36-)

4: Battery runs down quickly.

• Is the battery fully charged? Charge it with the AC adapter.

(

-10-)

• Are you using the battery in an extremely cold place? The

battery is affected by ambient temperature. In cold places,

the operating time of the battery becomes shorter.

• Has the battery worn out? The battery has a limited life. If the

operating time is still too short even after the battery is fully

charged, depending on the usage, the battery has worn out

and can no longer be used.

5: The camera-recorder cannot be operated though

powered up. The camera-recorder does not operate

normally.

• Remove the cassette and then press the reset button. (

-36-) If

normal conditions are not restored yet, turn off the power.

Then, about 1 minute later, turn on the power again.

6: The cassette cannot be removed.

• Does the power lamp comes on when opening the cassette

cover? (

-12-) Make sure that the battery and the AC adapter

are properly connected. (

-10-)

• Is the battery in use discharged? Charge the battery and

remove the cassette.

• Close the cassette cover completely, and fully open it again.

(

-12-)

7: No operation other than cassette removal can be

performed.

• Has condensation occurred? Wait until the condensation

indication disappears. (

-36-)

8: The remote control does not function.

• Has the coin-type battery of the remote control run out?

Replace it with a new button-type battery. (

-16-)

• Is the setting on the remote control correct? If the setting on

the remote control is not in agreement with the [REMOTE]

setting on the camera-recorder, the remote control does not

operate. (

-17-)

Functions Conditions which disable the

functions

≥Image stabilizer ≥When the color night view

function is used

≥Backlight

compensation

≥When the iris/gain is set

≥When the color night view

function is used

≥Soft skin

≥Tele-macro

≥Recording check

≥Color Night View

≥While recording to a tape

≥Zoom microphone

≥Wind noise reduction

≥An external microphone is used

≥Scene mode ≥When setting the

[AUTO/MANUAL/FOCUS]

switch to [AUTO]

≥When the color night view

function is used

≥Change of white

balance

≥When digital zoom (exceeds

10k) is used

≥When the color night view

function is used

≥When a menu is displayed

≥Adjusting the shutter

speed, iris/gain

≥When the color night view

function is used

≥When the scene mode is used

≥Variable-speed search ≥During repeat playback

≥Audio dubbing ≥The section of a tape recorded in

LP mode

≥The blank section of a tape

≥Sounds sent through the DV

terminal

DVC20_Eng.book 34 ページ２００６年４月６日　木曜日　午前１０時１０分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic AG-DVC 20p Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info