Bedienungsanleitung Panasonic AG-HVX 200AP (Seite 120 von 138) (Englisch)

597941

120

Zoom out

Zoom in

Vorherige Seite

1/138

Nächste Seite

120

Before calling for service

Power supply

There’s no power. • Make sure the battery and AC adapter are connected properly.

Check the connections again.

P 17

Power shuts off for no

apparent reason.

• To prevent the battery from running down needlessly and to

safeguard the tape from wear, the camera-recorder automatically

turns off when the camera-recorder has been left in the shooting

pause mode for more than 5 minutes.

Check the settings in the OTHER FUNCTIONS screen, POWER

SAVE.

P 118

Power goes off as soon as

it is turned on.

• The battery may have run out.

If the remaining battery charge display is blinking or

appears, the battery has run out. The same is true if, when the

power is turned on, the CAM, MCR and PC lamps flash in this

sequence and then the power goes off.

Either recharge the battery or replace the discharged battery with a

fully charged one.

P 16

• Condensation may have formed.

When, for instance, the camera-recorder is taken from a cold place

to a heated room, condensation may from inside. If this happens,

the camera automatically turns off and the only operation that

you will be able to perform is to remove the tape. Wait until the

condensation has dried out.

P 126

Battery

The battery runs down

quickly.

• Make sure the battery is fully charged.

Keep charging until the AC adapter’s CHARGE lamp goes out.

P 16

• Are you using the battery in a cold place?

The battery is affected by the ambient temperature. Its operating

time is reduced in low-temperatures.

—

• The battery may have reached the end of its service life. The

battery will become unchargeable. The battery has a certain

service life which varies depending on how the battery is used. If

the battery operates only for a short period even when it is charged

adequately, it has reached the end of its service life.

—

The battery cannot be

charged.

• The battery cannot be charged if the DC cord is connected.

Disconnect it.

—

Shooting (general)

Cannot start shooting. • Make sure the POWER switch is ON. P 20

• Condensation may have formed. If this happens, the only operation

that you will be able to perform is to remove the tape. Wait until the

condensation has dried out.

P126

Cannot focus automatically. • Make sure the camera is in manual mode. You can focus

automatically when the auto focus mode is selected.

P 38

• You may be shooting a scene where it is difficult to bring the subject

into focus in the auto focus mode.

If this is the case, focus in the manual focus mode.

It may be hard to bring the subject into focus when

· both close and distant objects are to be shot

· shooting through a dirty window

· shooting in a dark place

· there are sparkling or shiny objects around the subject

· the subject is moving fast

· shooting a scene with minimal contrast

—

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic AG-HVX 200AP Seite 120

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info