99987
17
Zoom out
Zoom in
Vorherige Seite
1/134
Nächste Seite
17
2
4
3
2
1
2-4 Menu operation section
1 MENU button
This is used to switch the menu ON and OFF.
2 JOG dial button
This is used to select the menu items and perform
settings when the MENU button 1 is at the ON position.
3 Setup card insertion slot
This is where the SD memory card (optional accessory) is
inserted into the unit.
4 BUSY (operation mode display) lamp
This lamp shows the operation mode of the setup card. It
lights during operation.
<Note>
When this lamp is lighted, refrain from inserting or
removing the card.
Chapter 2 Parts and their functions
(continued)
J DVCPRO connector
This is an output connector for video, voice, and data that
comply with the IEEE1394 standard.
<Notes>
O It is impossible to input signals from external devices.
O Power is not supplied from the unit.
O Before proceeding to connect or disconnect the DV
cable (IEEE1394), be absolutely sure to turn off the
power of the units that are to be connected or
disconnected using this cable.
O Before proceeding to connect
the unit which uses a 6-pin
type of DV connector,
carefully check the shape of
the connectors on the DV
cable and unit. Connecting a
connector upside down may
damage the parts inside the
camera-recorder and cause
malfunctioning.
Always connect the DV cable to the unit with the 6-pin
type DV connector first.
O You can connect a digital video unit equipped with a
DV connector and digitally transfer video and audio
signals as well as time codes and other information.
O When a DV cable has been connected to the DV
connector, do not apply any strong external force as
this may damage the connector.
O To control start/stop of recording operation on the
external recording device connected to the DVCPRO
connector using the unit, set the 1394 CONTROL item
on the menu (OPTION MODE screen on the SYSTEM
SETTING page) to BOTH (the default setting when
shipped from the factory is BOTH).
O When the FireStore FS-100 is used in 1080i mode as
an external recording device, set the VITC UB MODE
item (TC/UB screen on the VTR MENU page) to FRM
RATE, so that the frame rates of the unit can be
displayed on the display panel of the FS-100.
If it is used in 720P mode, frame rates are not
displayed properly but video images will be recorded
properly.
6-pin type
4-pin type
01.AJ-HDX900_P_E(VQT0X86)_E 06.6.22 12:52 PM ページ17
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic AJ-HDX900 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info