Bedienungsanleitung Panasonic EY45A2 (Seite 18 von 176) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

568605

Zoom out

Zoom in

Vorherige Seite

1/176

Nächste Seite

Alignment marks

3. During charging, the charging lamp will be

Illuminated.

When charging is completed, an internal elec-

tronic switch will automatically be triggered to

prevent overcharging.

• Charging will not start if the battery pack

is warm (for example, immediately after

heavy-duty operation).

The orange standby lamp will be flashing

until the battery cools down.

Charging will then begin automatically.

4. The charge lamp (green) will flash slowly

once the battery is approximately 80%

charged.

5. When charging is completed, the charging

lamp in green color will turn off.

6. If the temperature of the battery pack is 0 °C

or less, charging takes longer to fully charge

the battery pack than the standard charging

time.

Even when the battery is fully charged, it will

have approximately 50% of the power of a

fully charged battery at normal operating tem-

perature.

7. Consult an authorized dealer if the charging

lamp (green) does not turn off.

8. If a fully charged battery pack is inserted into

the charger again, the charging lamp lights

up. After several minutes, the charging lamp

in green color will turn off.

[Battery Charger]

Charging

CAUTION:

• The charger is designed to operate on

standard domestic electrical power only as

stated in the rating plate. Charge only on the

voltage indicated on the rating plate of unit.

e.g.230V / 50Hz.

• Do not attempt to use it on any other voltage

or frequency rating!

• If the temperature of the battery pack falls

approximately below −10 °C (14 °F), charging

will automatically stop to prevent degradation

of the battery.

• Do not charge the battery pack whose tem-

perature is below 0 °C (32 °F).

• When charging a cool battery pack (below

0 °C (32 °F)) in a warm place, leave the bat-

tery pack at the place and wait for more than

one hour to warm up the battery to the level

of the ambient temperature.

Otherwise battery pack may not be fully

charged.

•

Cool down the charger when charging more

than two battery packs consecutively.

• Do not insert your fingers into contact hole,

when holding charger or any other occasions.

CAUTION:

To prevent the risk of fire or damage to the bat-

tery charger.

• Do not cover vent holes on the charger and

the battery pack.

• Unplug the charger when not in use.

NOTE:

Your battery pack is not fully charged at the

time of purchase. Be sure to charge the

battery before use.

How to charge

1. Plug the charger into the AC outlet.

NOTE:

Sparks may be produced when the plug is

inserted into the AC power supply, but this is

not a problem in terms of safety.

Connect the battery pack firmly into the charger.

Line up the alignment marks and place the

battery onto the dock on the charger.

Slide forward in the direction of the arrow.

EY45A2(EU).indb 18 2014-1-15 10:13:12

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic EY45A2 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info