Bedienungsanleitung Panasonic sc dp 1 (Seite 4 von 36) (Englisch)

370467

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

RQT6817

Getting started

Caution for AC Mains Lead

(For United Kingdom)

(“EB” area code model only)

For your safety, please read the following text carefully.

This appliance is supplied with a moulded three pin mains plug for

your safety and convenience.

A 5-ampere fuse is fitted in this plug.

Should the fuse need to be replaced please ensure that the

replacement fuse has a rating of 5-ampere and that it is approved by

ASTA or BSI to BS1362.

Check for the ASTA mark

or the BSI mark

on the body of the fuse.

If the plug contains a removable fuse cover you must ensure that it is

refitted when the fuse is replaced.

If you lose the fuse cover the plug must not be used until a

replacement cover is obtained.

A replacement fuse cover can be purchased from your local dealer.

If a new plug is to be fitted please observe the wiring code as stated below.

If in any doubt please consult a qualified electrician.

IMPORTANT

The wires in this mains lead are coloured in accordance with the

following code:

Blue: Neutral, Brown: Live.

As these colours may not correspond with the coloured markings

identifying the terminals in your plug, proceed as follows:

The wire which is coloured Blue must be connected to the terminal

which is marked with the letter N or coloured Black or Blue.

The wire which is coloured Brown must be connected to the terminal

which is marked with the letter L or coloured Brown or Red.

WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH

TERMINAL WHICH IS MARKED WITH THE LETTER E, BY THE

EARTH SYMBOL

OR COLOURED GREEN OR GREEN/YELLOW.

THIS PLUG IS NOT WATERPROOF—KEEP DRY.

Before use

Remove the connector cover.

How to replace the fuse

The location of the fuse differ according to the type of AC mains plug

(figures A and B). Confirm the AC mains plug fitted and follow the

instructions below.

Illustrations may differ from actual AC mains plug.

1 Open the fuse cover with a screwdriver.

2 Replace the fuse and close or attach the fuse cover.

CAUTION!

IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE

SOCKET OUTLET IN YOUR HOME THEN THE FUSE

SHOULD BE REMOVED AND THE PLUG CUT OFF AND

DISPOSED OF SAFELY.

THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF

THE CUT OFF PLUG IS INSERTED INTO ANY 13-AMPERE

SOCKET.

Fuse cover

Figure A

Figure B

Fuse

(5 ampere)

Fuse

(5 ampere)

Figure A

Figure B

Glossary

Decoder

A decoder restores the coded audio signals on DVDs to normal. This

is called decoding.

Dolby Digital

This is a method of coding digital signals developed by Dolby

Laboratories. Apart from stereo (2-channel) audio, these signals can

also be multi-channel audio. A large amount of audio information can

be recorded on one disc using this method.

DTS (Digital Theater Systems)

This surround system is used in many movie theaters around the

world. There is good separation between the channels, so realistic

sound effects are possible.

Dynamic range

Dynamic range is the difference between the lowest level of sound

that can be heard above the noise of the equipment and the highest

level of sound before distortion occurs.

Film and video

DVD-Videos are recorded using either film or video. Usually, film is

recorded at 24 frames per second, the rate movies are filmed at,

while video is recorded at 30 frames per second.

Frame still and field still

Frames are the still pictures that go together to make a moving

picture. There are about 30 frames shown each second.

One frame is made up of two fields. A regular television shows these

fields one after the other to create frames.

A still is shown when you pause a moving picture. A frame still is

made up of two alternating fields, so the picture may appear blurred,

but overall quality is high.

A field still is not blurred, but it has only half the information of a

frame still so picture quality is lower.

Interlace and progressive output

NTSC, the video signal standard, has 480 interlaced (I) scan lines,

whereas progressive scanning uses twice the number of scan lines.

This is called 480P. The video signals output from this unit’s

COMPONENT VIDEO OUT terminals (Y, P

B, PR) allow you to enjoy

higher quality pictures than if the signals were output from the

VIDEO OUT terminal or S-VIDEO OUT terminal.

I/P/B

MPEG 2, the video compression standard adopted for use with

DVD-Video, codes frames using these 3 picture types.

I: Intra coded picture

This picture has the best quality and is the best to use when

adjusting the picture.

P: Predictive coded picture

This picture is calculated based on past I or P-pictures.

B: Bidirectionally-predictive coded picture

This picture is calculated by comparing past and future I and

P-pictures so it has the lowest volume of information.

Linear PCM (pulse code modulation)

These are uncompressed digital signals, similar to those found on

CDs.

Playback control (PBC)

If a Video CD has playback control, you can select scenes and

information with menus.

6817b-p04-25.fm 4 ページ２００３年７月４日　金曜日　午後６時１５分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic sc dp 1 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic sc dp 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info