Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart
do not solve the problem, consult your dealer for instructions.
No play.
The disc isn’t correctly set.
The disc is scratched or dirty. (Tracks skipped.)
There is moisture on the lens. Wait for about an hour and then try again.
•
•
•
MP3 cannot be read.
You may not be abl e to pl ay MP3 if you have co pied a multi-s ession disc th at has no data betwee n sessi ons.
When creating a multi session disc, it is necessary to close the session.
The amount of data on the disc is too small. Set the amount of data to greater than approximately 5 MB.
•
•
•
Sound is unfixed, reversed or
comes from one speaker only.
Check the speaker connections. (➡ page 4) •
No sound or there is a lot of
noise.
Noise may occur when playing MP3 if recording quality is poor.
Keep this unit away from mobile telephones if the interference is apparent.
Turn the volume up.
Switch the unit off, determine and correct the cause, then switch the unit on. Causes include shorting of the
positive and negative speaker wires, straining of the speakers through excessive volume or power, and using
the unit in a hot environment.
•
•
•
•
Humming heard during play.
An AC mains lead or fluorescent light is near the cords. Keep other appliances and cords away from this unit’s
cables.
•
A beat sound or noise is heard
while receiving a radio broadcast.
Switch the TV or other audio player off or separate it from the unit.
Switch off the portable audio player connected to “MUSIC PORT”.
•
•
A low hum or noise is heard
during AM broadcasts.
Keep the antenna away from other cables and cords.
Keep the AM antenna away from the unit.
•
•
The picture on the television near
the set disappears or stripes
appear on the screen.
The location and orientation of the antenna are incorrect.
The television antenna wire is too close to the unit. Separate the antenna wire of the television from the unit.
•
•
Remote control doesn’t work.
Check that the batteries are inserted correctly. (➡ page 3)
Replace the batteries if they are worn.
•
•
Display
--:--
You plugged the AC mains lead in for the first time and there was a power failure recently. Set the time.
(➡ page 9)
•
PGM FULL The number of programmed tracks is limited to 24. No further tracks can be programmed. •
NO PLAY A CD-ROM disc that is not CD-DA or MP3 format is inserted. It cannot be played. •
ERROR Incorrect operation performed. Read the instructions and try again. •
F76 There is a power supply problem. Consult the dealer. •
iPod
iPod does not turn on.
Verify that the iPod battery is not depleted before connecting it to the unit.
Before inserting your iPod into the dock, turn off both the unit and iPod. Power on the unit and select the
appropriate source.
Make sure PC is not connected to the main unit and activate PC Sync.
•
•
•
No sound is coming from the
speakers.
The iPod is not correctly inserted into the dock. Turn off the iPod, remove it from the dock connector. Reinsert
it and turn it on again.
Make sure that iPod is actually playing something.
Adjust the volume.
•
•
•
Music is distorted or the sound
level is too low.
Make sure the equalizer function of your iPod is turned off. •
Cannot control the iPod from the
CD Stereo System.
Make sure the iPod is inserted properly into the dock.
Check the dock connection and make sure that iPod is selected as the source of music. (➡ page 7)
•
•
iPod does not charge.
Check all connections. (➡ page 4) •
Unable to use PC Sync.
Turn the unit on.
Check PC and iPod connections. (➡ page 7)
•
•
USB
No response when [USB q /h ]
button is pressed.
Disconnect the USB device and then reconnect it back. Alternatively, turn the unit off and then back on. •
The USB drive or it’s contents
cannot be read.
The USB drive format or it’s contents is/are not compatible with the system. (➡ page 8)
The USB host function of this product may not work with some USB devices.
USB devices with storage capacity of more than 8 gigabytes may not work in some instances.
•
•
•
Slow operation of the USB flash
drive.
Large file size or high memory USB flash drive takes longer time to read. •
“USB OVER CURRENT ERROR”
The USB mass storage device rating exceeds 500mA. Disconnect the USB device. Turn the unit off and then
back on.
•
“NO PLAY”
Check the content.
Only MP3 format files can be played.
•
•
Troubleshooting guide
1
RQTV0293
For your safety, please read the following text carefully.
This appliance is supplied with a moulded three pin mains plug for your
safety and convenience.
A 5-ampere fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the replacement
fuse has a rating of 5-ampere and that it is approved by ASTA or BSI to
BS1362.
Check for the ASTA mark or the BSI mark on the body of the fuse.
If the plug contains a removable fuse cover you must ensure that it is
refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement
cover is obtained.
A replacement fuse cover can be purchased from your local dealer.
If a new plug is to be fitted please observe the wiring code as stated below.
If in any doubt please consult a qualified electrician.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following
code:
Blue: Neutral, Brown: Live.
As these colours may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured Blue must be connected to the terminal which is
marked with the letter N or coloured Black or Blue.
The wire which is coloured Brown must be connected to the terminal which
is marked with the letter L or coloured Brown or Red.
WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH
TERMINAL WHICH IS MARKED WITH THE LETTER E, BY THE EARTH
SYMBOL OR COLOURED GREEN OR GREEN/YELLOW.
THIS PLUG IS NOT WATERPROOF–KEEP DRY.
Before use
Remove the connector cover.
How to replace the fuse
The loca tion of t he fu se d iffer acco rdin g to the t ype of AC main s pl ug (f igure s
A a nd B) . Co nfirm the AC m ains plug fitt ed an d fol low the i nstru ctio ns be low.
Illustrations may differ from actual AC mains plug.
1. Open the fuse cover with a screwdriver.
2. Replace the fuse and close or attach the fuse cover.
� Sales and Support Information
Customer Care Centre
For UK customers: 0844 844 3852
For the Republic of Ireland customers: 01 289 8333
Visit our website for product information
E-mail: customer.care@panasonic.co.uk
Direct Sales at Panasonic UK
Order accessory and consumable items for your product with ease
and confidence by phoning our Customer Care Centre Monday-Friday
9:00am-5:30pm. (Excluding public holidays)
Or go on line through our Internet Accessory ordering application at
www.panasonic.co.uk
Most major credit and debit cards accepted.
All enquiries transactions and distribution facilities are provided directly
by Panasonic UK Ltd.
It couldn’t be simpler!
Also available through our Internet is direct shopping for a wide range of
finished products, take a browse on our website for further details.
Interested in purchasing an extended guarantee?
Please call 0870 240 6284 or visit our website
www.panasonic.co.uk/guarantee
.
•
•
•
•
•
•
•
•
•
•
1. Open the fuse cov er with a screwdriver .
2. Replace the fuse and close or attach the fuse cov er.
2. Replace the fuse and close or attach the fuse cov er.
CAUTION!
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET
OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE REMOVED
AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT
OFF PLUG IS INSERTED INTO ANY 13-AMPERE SOCKET.
by AST A or BSI to BS1362.
Check f or the AST A mark or the BSI mark on the body of
Check f or the AST A mark or the BSI mark on the body of
EARTH TERMINAL WHICH IS MARKED WITH THE LETTER
E, BY THE EARTH SYMBOL OR COLOURED GREEN OR
caution for AC mains lead.indd 1 1/15/2008 6:33:34 PM
SC-EN38_E,EB,GN,GCS (RQTV0293)_MP.indd 10 2/18/2008 2:11:38 PM