563924
13
Zoom out
Zoom in
Vorherige Seite
1/84
Nächste Seite
13
RQT9886
ENGLISH
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1 Press [CD/RADIO] to select “CD”.
2 While pressing and holding [SELECTOR] on the
unit, press and hold [CD/RADIO] on the remote
control until the unit’s display shows “REMOTE 2”.
3 Press and hold [OK] and [CD/RADIO] on the
remote control for at least 4 seconds.
To change the mode back to “REMOTE 1”, press [CD/RADIO]
to select “CD” and then repeat the step 2 and 3 but replace
[CD/RADIO] with [ ].
Occasionally, Panasonic may release updated
software for this unit that may add or improve the way
a feature operates. These updates are available free of
charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
Checking the software version
The version of the installed software is displayed.
Press [SETUP] repeatedly to select “SW VER.” and
then press [OK].
Press [OK] to exit.
Troubleshooting
Before requesting service, make the following checks.
If you are uncertain about some of the check points, or
if the solutions indicated in the following guide does not
resolve the issue, then consult your dealer for
instructions.
Humming heard during playback.
If an AC mains lead or fluorescent lights are near the cords, then
keep other appliances and cords away from the cables.
The unit does not work.
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
1 Press [Í/I] on the unit to switch the unit to standby.
If the unit does not switch to standby, press [Í/I] on the unit
for approximately 10 seconds. The unit is forcibly switched
to standby. Alternatively, disconnect the AC mains lead, wait
for at least 3 minutes, then reconnect it.
2 Press [Í/I] on the unit to switch it on. If the unit still cannot be
operated, consult the dealer.
MP3 cannot be read.
You may not be able to play MP3 if you have copied a
multi-session disc that has no data between sessions.
When creating a multi-session disc, it is necessary to close the
session.
The amount of data on the disc is too small. Set the amount of
data to above 5 MB.
The remote control does not work properly.
The battery is depleted or inserted incorrectly. (l 4)
Incorrect display or play does not start.
Make sure that the disc is compatible with this unit. (l 16)
There is moisture on the lens. Wait for about an hour and then try
again.
Changing the unit and remote
control code
Software update
To return all settings to the factory defaults
When the following situations occur, reset the
memory:
There is no response when buttons are pressed.
You want to clear and reset the memory contents.
1 Disconnect the AC mains lead. (Wait for at least
3 minutes before proceeding to step 2.)
2 While pressing and holding down [Í/I] on the
unit, reconnect the AC mains lead.
Keep holding down [Í/I] until “---------” appears on the
display.
3 Release [Í/I].
All the settings are returned to the factory defaults. You will
need to reset the memory items.
General
Remote control
Disc
SC-HC49EG~RQT9886-R.book 13 ページ 2014年4月3日 木曜日 午前9時29分
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

panasonic-sc-hc49

Suche zurücksetzen

  • Beim einlegen einer DVD lässt sich diese nicht abspielen Eingereicht am 8-2-2024 12:08

    Antworten Frage melden
  • Ich habe mein SC-HC49 vom Stromnetz getrennt. Nach dem neuen Anschluss an das Stromnetz erscheint im Display "Insert USB" Eingereicht am 11-9-2023 16:11

    Antworten Frage melden
  • Das Gerät schaltet sich (nach "normalem" Abschalten!) immer wieder mal selbst ein!
    Hilfe! Eingereicht am 30-10-2020 16:02

    Antworten Frage melden
  • kann das gerät ohne usb - anschluß genutzt werden ? Eingereicht am 2-9-2018 09:39

    Antworten Frage melden
  • Im Display wechselt Anzeige zwischen USB und Insert ständig, so das Gerät sich nicht bedienenen lässt Eingereicht am 30-4-2018 19:17

    Antworten Frage melden
  • Mein Gerät lässt sich nicht einschalten, keine Anzeige Eingereicht am 3-10-2017 16:11

    Antworten Frage melden
  • fernbedienung von anlage reagiert nicht.im display wird remote 1 angezeigt .batterien sind neu Eingereicht am 22-4-2017 10:35

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic SC-HC49 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Panasonic SC-HC49

Panasonic SC-HC49 Bedienungsanleitung - Deutsch, Holländisch - 92 seiten

Panasonic SC-HC49 Bedienungsanleitung - Dänisch, Französisch - 68 seiten

Panasonic SC-HC49 Bedienungsanleitung - Französisch, Italienisch - 92 seiten

Panasonic SC-HC49 Bedienungsanleitung - Schwedisch, Finnisch - 68 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info