Bedienungsanleitung Panasonic SCHTX5 (Seite 8 von 28) (Englisch)

618350

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

RQT9478

Installing and assembling the rack

Connection

Glass shelf assembly

Loosen the screws (included) for the glass

shelf and insert the protrusions of the glass

holders (included) to the holes inside the

rack.

• Insert to the left and right holes with the same height.

• The height of the shelf can be adjusted at 2 different levels.

• Change the positions of holes for the glass holder to adjust

the height of shelf.

• When you do not install the shelf, keep the glass holders in a

safe place.

Insert the glass shelf (included) from front

to between the glass holders.

• Insert the glass shelf with its label side up and at right.

• Make sure the glass shelf has been set between both glass

holders before inserting.

• Set the glass shelf so its nonslip sheets are hidden under the

glass holders.

Tighten the screws for the glass shelf from

the bottom.

• Tighten the screws for the glass shelf ﬁ rmly and ﬁ x it so it

does not move.

• You can tighten the screws easily when you slightly lift the

glass shelf.

Tighten from the bottom.

Label

Nonslip sheet

(dotted line part)

Glass shelf

Loosen

screws at

this height.

Screws for glass shelf

Glass

holder

Protrusion

Inside the rack

About equipment stored on the shelf

unit (mm)

Setting position

Shelf board

position

Height of

compartment

Maximum depth for

storing equipment

Recommended width

of equipment

Width of compartment

Upper shelf A

Upper 117

340 430 610

Lower 144

Lower shelf B

Upper 147

Lower 114

• Do not put equipment weighing more than 12 k

on the upper shelf

and lower shelf

• Image interference may occur if you put recording equipment such as a DVD recorder on the upper shelf

. Put it on the lower

shelf

if this occurs.

• When you install equipment with a heat dissipation louvers on the back side, make sure the heat dissipation louvers are not

blocked by the wire dressing part at the back center of the rack.

(Upper view)

Front

Back

Note

Installing the television (Please also refer to the television’s operating instructions.)

Recommended: 42 inches or less

Place the TV stand in the center of the top board of the rack.

• Do not put equipment weighing more than 80 k

on the top board.

• The TV stand may be sold separately.

• Lift the television when placing it on the rack. Dragging it may damage the top panel.

(For details, refer to the television’s operating instructions.)

• When you use a stand with a rotating function, keep distance so the TV does not hit the wall.

• This system is not magnetically shielded. Do not put a CRT-based television.

(Upper view of the setup)

Wall

Arrange the

stand so

the TV does

not hit the

wall when

rotated.

Stand

Note

Installing and assembling the rack

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SCHTX5 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic SCHTX5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info