Bedienungsanleitung Panasonic SCVK31 (Seite 12 von 56) (Englisch)

618673

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

RQT7703

ENGLISH

The radio: manual tuning

Preparation:

Press [TUNER/AUX] to select “FM” or “AM”.

Automatic presetting

Do the following once each for FM and AM.

Preparation: Tune to the frequency where pre-setting is to begin.

Hold down [PROGRAM] until the frequency changes.

The tuner presets all the stations it can receive into the channels in

ascending order. When finished, the last station memorized is tuned in.

Manual presetting

Pre-set the stations one at a time.

1 Press [PROGRAM] then press [( REW] or [) FF] to tune

to the desired station.

2 Press [PROGRAM] then press [g 3] or [f 4] to select

a channel.

3 Press [PROGRAM].

The station occupying a channel is erased if another station is preset

in that channel.

Sele

cting channels

Press the numbered buttons to select the channel.

To enter channel 10 or over, press [

10], then the two digits.

1 Press [PLAY MODE] to select “PRESET”.

2 Press [g 3] or [f 4] to select the channel.

The radio: preset tuning

Remote control only

There are two methods of pre-setting stations.

Automatic presetting : All the stations the tuner can receive are

preset.

Manual presetting : You can select the stations to preset and the

order they are preset in.

Up to 15 stations each can be set in the FM and AM bands.

1 Press [TUNER, BAND] to select band.

The unit comes on.

Every time you press the button:

FM ↔ AM

2 Press [PLAY MODE] on the remote control to select

“MANUAL”.

Every time you press the button:

MANUAL ↔ PRESET

3 Hold down [

g/REW/

3] or [

4/FF/

f] for a moment

to search for a station.

The frequency stops when it finds a clear station.

To stop during the process, press [g/REW/3] or [4/FF/f].

Under excessive interference, a station may not be found.

Press [g/REW/3] or [4/FF/f] repeatedly to tune step-by-

step.

“TUNED” is displayed when a radio station is tuned.

“ST” is displayed when a stereo FM broadcast is being received.

If noise is excessive in FM

Remote control only

Hold down [PLAY MODE] to display “MONO”.

Monaural sound is selected and noise reduces when reception is

weak.

Hold down [PLAY MODE] again to cancel the mode.

“MONO” is also cancelled if the frequency is changed.

AM allocation setting

Main unit only

By adjusting the allocation, you can enable this tuner to receive AM

broadcasts allocated in 10 kHz steps.

Press and hold [TUNER, BAND]. After a few seconds, the display will

change to a flashing display of the current minimum AM frequency. If

you continue to hold the button down, the minimum frequency will

change. Release the button at this time.

To return to the original frequency indication, repeat above.

Note

•

After changing the “allocation” setting, the frequencies you previously

preset in the memory will be cleared.

•

Sound is momentarily interrupted if you load/unload tapes while

listening to AM broadcast.

PROGRAM

PLAY MODE

TUNER/

AUX

REW,

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SCVK31 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic SCVK31

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info