Bedienungsanleitung Parkside IAN 273460 PTK 2000 B2 (Seite 50 von 204) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

745555

Zoom out

Zoom in

Vorherige Seite

1/204

Nächste Seite

GB IE

Caution with incision cutting.

Operate the device only with a suction sys-

tem. Check and clean the suction channels

regularly.

Suitability of the saw blades:

- 24 teeth: soft materials, high chip

removal, rough cut image

- 48 teeth: hard materials, lower chip



Performing Longitudinal

Cuts

(Figure 35)

Here, a workpiece is cut in its longitudinal

direction. One edge of the workpiece

is pressed against the parallel stop (14)



The saw blade guard (2) must always be

lowered onto the workpiece. The working

position during longitudinal cutting must

never be in a straight line with the cutting

line.

- Adjust the parallel stop (14) according

to the workpiece height and the desi-

red width.

- Switch on the saw.

 



and push the workpiece along the

parallel stop (14) into the saw blade

(5).

- Guide from the side with your left or

right hand (depending on the position

of the parallel stop) only up to the front

edge of the saw blade guard (2).

- Always push the workpiece through to

the end of the riving knife (4).

- The cutting waste remains on the saw

table (1) until the saw blade (5) is

back in its resting position.

- Secure long workpieces against tilting

at the end of the cutting process! (e.g.

unwinding stand etc.)

Cutting narrow

Workpieces

(Figure 36)

Longitudinal cuts of workpieces with a

width of less than 120 mm always have to

be cut with the help of a push stick (17).

The push stick is included in the scope of

delivery. Replace a worn or damaged

push immediately.

• Adjust the parallel stop according to

the planned workpiece width.

• Advance the workpiece with both

hands, making sure that you use a

push stick (17) as a pushing aid in the

vicinity of the saw blade.

• Always push the workpiece through to

the end of the riving knife.

Caution! In the case of short work-

pieces, the push stick should be

used from the beginning of the

cutting process.

Cutting very narrow

Workpieces

(Figure 37)

For longitudinal cuts of very narrow work-

pieces with a width of 30 mm and less, a

push block must be used without fail. There

is no push block included in the scope of

delivery! (Available from specialist shops)

Replace a worn push block as soon as

possible.

• The parallel stop should be adjusted to

the cutting width of the workpiece.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Parkside IAN 273460 PTK 2000 B2 Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info