Bedienungsanleitung Parkside IAN 307044 PKS 2200 A1 (Seite 41 von 196) (Deutsch, Englisch, Holländisch, Französisch, Polnisch)

749294

Zoom out

Zoom in

Vorherige Seite

1/196

Nächste Seite

IEGB

• Follow instructions for lubricat-

ing, chain tensioning and chang-

ing accessories. Improperly tensioned

or lubricated chain may either break

or increase the chance for kickback.

• Keep handles dry, clean, and

free from oil and grease. Greasy,

oily handles are slippery causing loss

of control.

• Cut wood only. Do not use chain

saw for purposes not intended.

For example: do not use chain

saw for cutting plastic, masonry

or non-wood building materials.

Use of the chain saw for operations

different than intended could result in a

hazardous situation

Causes and operator

prevention of kickback

Beware of kickback! Be careful of

kickback of the machine during

work. There is danger of injury

here. You can avoid kickbacks by

exercising caution and using a cor-

rect sawing technique.

Fig. 1

• Kickback may occur when the nose or

tip of the guide bar touches an object,

or when the wood closes in and pinch-

es the saw chain in the cut

 

• Tip contact in some cases may cause

a sudden reverse reaction, kicking the

guide bar up and back towards the



• Pinching the saw chain along the top

of the guide bar may push the guide

bar rapidly back towards the operator.

• Either of these reactions may cause

you to lose control of the saw which

could result in serious personal injury.

Do not rely exclusively upon the safety

devices built into your saw. As a chain

saw user, you should take several steps

to keep your cutting jobs free from ac-

cident or injury.

Kickback is the result of tool misuse and/

or incorrect operating procedures or condi-

tions and can be avoided by taking proper

precautions as given below:

• 



the chain saw handles, with

both hands on the saw and po-

sition your body and arm to al-

low you to resist kickback forc-

es. Kickback forces can be controlled

by the operator, if proper precautions

are taken. Do not let go of the chain

saw.

• Do not overreach and do not cut

above shoulder height. This helps

prevent unintended tip contact and

enables better control of the chain saw

in unexpected situations.

• Only use replacement bars and

-

facturer. Incorrect replacement bars

and chains may cause chain breakage

and/or kickback.

• Follow the manufacturer´s

sharpening and maintenance

instructions for the saw chain.

Decreasing the depth gauge height

can lead to increased kickback.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Parkside IAN 307044 PKS 2200 A1 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info