764032
34
Zoom out
Zoom in
Vorherige Seite
1/132
Nächste Seite
33 GB/IE
Belt clip
(Fig. J)
The belt clip 9 is not assembled upon delivery.
The belt clip can be mounted on either side of a
belt (required tool: Cross tip screwdriver).
¾Loosen the belt clip’s 9 screw.
¾Insert the belt clip 9 on either side of the
product. Tighten the screw.
Operation
Attaching/removing the
battery pack
m CAUTION! RISK OF INJURY!
uAlways lock the on/off switch 6 to avoid
accidental starting by moving the rotation
direction switch 5 into the centre position
(Lock) before attaching/removing the
battery pack
10
.
¾Removing the battery pack: Press the
battery pack release button
12
. Remove the
battery pack
10
(Fig. D).
¾Attaching the battery pack: Align the
battery pack
10
to the handle and slide it
into it. Ensure it clicks noticeably in place.
The battery pack can only be inserted into
the product in one direction.
Checking the battery pack
charging level
(Fig. B)
¾Check battery pack charge level: Press the
button
13
. The charging level LEDs
14
light up:
LED
14
Charging level
Red / orange / green Maximum
Red / orange Medium
Red Low
Charging the battery pack
(Fig. C)
NOTE
uThe battery pack
10
may be charged at
any time without reducing the life.
uInterrupting the charging process does not
damage the battery pack
10
.
¾Charge the battery pack
10
before
operation when it is at medium or low
charging level.
¾The charging control LEDs (green
17
and
red
18
) indicate the status of the charger
15
and the battery pack
10
:
LED Status
Red LED lights up Battery pack
charges
Green LED lights up Battery pack fully
charged
Green and red LED
flashing
Battery pack
defective
Red LED flashing Battery pack too
cold or too warm
Green LED lights up
(without battery pack)
Charger ready
¾Insert the battery pack
10
into the charger
15
.
¾Connect the power cord with power plug
16
of the charger
15
to the socket.
¾When the battery pack
10
is fully charged:
Remove the battery pack from the charger
15
. Then disconnect the power plug
16
of
the charger from the socket.
34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Parkside PABSP 20-Li B2 - IAN 322691 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info