8GB/IE/NI/CY/MT
Ensure you hand over all documentation
when passing the product on to anyone
else. Any use that differs to the intended
use as stated above is prohibited and
potentially dangerous. Damage or injury
caused by misuse or disregarding the
above warning is not covered by the
warranty or any liability on the part
of the manufacturer. The device should
only be used by specialists or those who
been trained. Commercial use will void
the guarantee. Observing the safety
instructions and assembly instructions
and operating information in the instruc-
tions for use is also a component of the
intended use.
It is imperative to adhere to the applica-
ble accident prevention regulations.
The device must not be used:
in insuffi ciently ventilated rooms,
in explosive environments,
to defrost pipes,
in the vicinity of people with
cardiac pacemakers and
in close proximity to easily
fl ammable materials.
Residual risk
Even if you operate the device as
intended, there will be residual risks.
The following dangers may occur in
connection with the build and design
of this multi-welder:
Eye injuries due to glare,
Touching hot parts of the device or
workpiece (burn injury),
In case of improper protection risk of
accident and fi re through sparks and
slag particles,
Harmful emissions from smoke and
gases if there is a lack of air or
if closed rooms are insuffi ciently
extracted.
Reduce the residual risk by carefully
using the device as intended and
observing all instruction.
Package contents
1 Multi-Welder PMSG 200 A1
1 1.0 welding nozzle (pre-fi tted,
only for solid aluminium wire)
labelling: 1.0 A
4 Welding nozzles for steel/
fl ux-cored wire (1x 0.6 mm;
1x 0.8 mm; 1x 0.9 mm;
1x 1.0 mm) labelling in
accordance with the diameter:
0.6; 0.8; 0.9; 1.0
1 Chipping hammer with wire brush
1 Solid aluminium wire 200 g (pre-
fi tted, 1.0 mm Ø, type: ER5356
1 Welding mask
1MMA electrode holder
1 Operating instructions
1 Earth terminal with cable
1 MIG torch with welding cable
1 Flux-cored wire 200 g 1.0 mm Ø,
Type: E71T-GS
5Rod electrodes (2 x 1.6 mm;
2 x 2.0 mm; 1 x 2.5 mm)
Parts description
1
Cover of the wire feed unit
2
Handle
3
Mains plug
4
Earth cable with earth terminal
5
Main switch ON/OFF
(incl. power indicator lamp)
6
Rotary switch for setting the welding
current
7
Torch nozzle
8
Torch
9
Torch button
10
Cable assembly with direct
connection
11
Welding nozzle (0.6 mm)
Introduction
