Bedienungsanleitung Peg Perego VIAGGIO SWITCHABLE (Seite 28 von 124) (Alle Sprachen)

626374

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

1C (Fig.B).

24• Use in Group 0+ mode: To determine the best

shoulder strap position, bear in mind that the child’s

shoulders must be just above the shoulder strap guides.

25• IMPORTANT: The straps must not be too high or

too low with respect to the child’s shoulders.

26• WARNING: Do not use the car seat in Group 1 mode

with the casing extracted.

27• Use in Group 1 mode: To determine the best shoulder

strap position, bear in mind that the child’s shoulders

must be just below the shoulder strap guides.

28• IMPORTANT: The straps must not be too high or

too low with respect to the child’s shoulders.

29• IMPORTANT: The “Viaggio 0+1 Switchable” car seat

can be reclined into 5 different positions only when it

is used in Group 1 mode.

To recline the car seat, press the lever under the

seat (Fig.A) and pull to adjust the seat to the desired

position (Fig.B).

How to remove the soft cover

To remove the soft cover of the “Viaggio 0+1

Switchable” car seat:

• Remove the booster cushion, where present (point 20).

• Unfasten the harness (point 13).

• Open the rear panel.

30• Unfasten the straps from the rear latch plate.

31• Unfasten the straps on the rear and slip them out from

the front.

32• Unfasten the shoulder pads from the rear and slip

them off the straps from the front.

33• Slip off the adjuster strap (Fig. C) and then remove the

headrest cover from above (Fig. D).

34• Release the crotch strap from below the body (Fig. E) and

slide the strap out through the crotch strap cover (Fig. F).

35• Slip the strap out through the opening in the soft cover

and remove the soft cover, as shown in the figure.

Soft cover maintenance

Brush the fabric parts to remove dust.

• Before placing the soft cover in the washing machine,

slide the foam rubber cushion out of the booster seat

from the rear.

17• Lock the harness by overlapping the tongues and

inserting them into the buckle of the crotch strap until

they click into place.

18• The child is now sitting correctly with the harness

fastened properly.

19• Finally, tighten the shoulder straps until they are snug

to the child’s body by pulling the central adjustment

strap towards you, as shown in the figure, taking care

not to over-tighten the straps.

IMPORTANT: Leave minimal slack (the space of

a finger) between the strap and the child's chest.

20• To slacken the straps, press the button at the centre

of the car seat and at the same time pull the straps

towards you.

IMPORTANT: Take hold of the straps under the

shoulder pads and pull, as shown in the figure.

21• The car seat has a booster cushion which is only

suitable for small babies. When the child is older,

remove the booster cushion.

• To remove the booster cushion, unfasten the seatbelts,

slide them off the booster cushion and slide the crotch

strap out through the slot in the booster cushion.

IMPORTANT: The booster cushion must be

removed when the “Viaggio 0+1 Switchable” is

used as a Group 1 car seat.

How to adjust the height of the headrest

The headrest must be adjusted to match the child’s

height. There are 7 positions.

22• To change from a lower position to a higher one: pull

the tongue in the upper central part of the headrest

upwards. The headrest will move at the same time.

To change from a higher position to a lower one: pull

the tongue in the upper central part of the headrest

upwards and, at the same time, push the headrest

down to the desired position.

When you have finished, try moving the headrest

to check it is properly locked into place.

23• WARNING: Do not use the car seat in Group 0+ mode

without first extracting the casing, as shown in point 1

A-B (Fig.A).

WARNING: Do not use the car seat in Group 0+ mode

without first reclining the backrest, as shown in point

• When washing, closely follow the instructions stated on

the label sewn into the cover.

• Do not use chlorine bleach.

• Do not iron.

• Do not dry clean.

• Do not remove stains with solvents.

• Do not tumble dry.

How to replace the soft cover of the

“Viaggio 0+1 Switchable” car seat

To replace the soft cover of the “Viaggio 0+1

Switchable” car seat:

36• From below, slip the straps back in through the

opening in the fabric (Fig. A).

• Reinsert the crotch strap into the soft cover (Fig. B).

37• Fasten the crotch strap back onto the body.

38• Fasten the tongue to the crotch strap opening.

39• Put the soft cover in place, starting at the seat and moving

upwards, paying attention to the sides of the backrest.

40• Slip the soft cover over the headrest, ensuring the red

tongue passes through the opening in the fabric.

41• Insert the straps through the soft cover, starting with

the buckles.

42• Lengthen the straps and insert them through the body

of the car seat (the straps in the upper hole and the

buckles in the lower one).

43• Fasten them correctly on the rear, as shown in the figure.

• Fasten the harness at the front (point 17).

IMPORTANT: The straps must not be twisted.

44• ATTENTION: The central adjustment strap must pass

between the body and the plastic shield, as shown.

45• Open the rear panel and fasten the straps onto the rear

latch plate.

• Fasten the straps from the front (point 16).

• For infants and for use in Group 0+ mode, reposition

the booster cushion.

Accessories

46• Clima Cover Car Seat: washable cover in Tencel,

a natural heat-regulating fiber that regulates body

moisture (warm in winter and cool in summer) (Fig. A).

• Travel Bag Car Seat: practical travel bag that keeps the

Peg Perego VIAGGIO SWITCHABLE Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info