Bedienungsanleitung PerfectPro SLIM 1 (Seite 4 von 25) (Deutsch, Englisch, Holländisch, Französisch)

742546

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

POWER SUPPLY

Battery operation

1. Toopenthebatterycompartment,rstturnthebatterycoverxturesanti-clockwise

to loosen and pull down the battery cover.

2. Insert 6 x AM3/AA/LR6 NiMH or alkaline batteries with the correct polarity into the

 compartment.Closethebatterycoverandfastenthexturesbyturningclockwise.

3. If the unit is not to be used for any extended period of time, it is recommended to

remove the batteries from the radio.

The approximate power level of the batteries is displayed in the LCD display of the

 radio.Whenthepowerlevelisverylowthebatterysymbolashesonthedisplay.

The batteries should then be replaced soon to continue normal operation of the

radio.

Notes:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type.

Donotexposethebatteriestoexcessiveheatsuchassunshine,reorthelike.

Batteries should not be disposed of by incineration and with household waste.

Disposable batteries should be taken to a suitable recycling centre if possible.

AC operation

Before plugging the AC power cord into the AC socket, be sure the voltage is correct.

If you have batteries in the radio and using the AC power supply, the batteries will

automatically be disconnect.

AC power cord storage is designed to store the cord when the radio is not in use.

Note:

In order to disconnect the unit from the AC mains completely, the AC power cord should

be removed from the mains socket completely. The AC power cord shall remain readily

operable and should not be obstructed during intended use.

Incaseofmalfunctionduetoelectrostaticdischargeorfasttransient(burst),removethe

power supply and all the batteries then reinstall the batteries and reconnect the power

supply.

GENERAL FUNCTIONS

1. Switching on and off

Press the POWER button to turn the radio on or in standby.

2. Switching in between FM / AUX IN modes

Press the SOURCE button to switch between modes.

3. Tuning the Radio

Tune the radio using the TUNING/SEEK knob on the right.

4. Adjusting the Volume

Adjust the volume with the VOLUME/TONE knob on the left.

5. Adjusting the Tone

Press and hold the Volume knob on the left for about 3 seconds and rotate it to

adjust the Bass and Treble.

USING THE DEVICE FOR THE FIRST TIME

1. Placetheradioonaatsurface.

2. Carefully extend the antenna located on the top of the radio. Adjust the antenna so

it is vertically extending above the radio.

3. Plugging the AC power cord into the AC socket. The radio will automatically perform

an auto scan the FM band in the back ground.

4. When the scan is completed, the 5 strongest FM stations will be stored as presets.

The radio will switch to standby with the updated clock showing on the display.

5. If no signals are found, the clock will not be updated. It may be necessary to

relocate the radio to a position giving better reception.

FM MODE

Seeking station

1. Press the POWER button to turn on the radio.

2. Select the FM waveband by pressing the SOURCE button.

3. IfthisisthersttimetoswitchtoFMmode,thestationinpreset1willbeplayed.

If the radio has been used before, the last listened station will be played.

4. To seek station, press the TUNING/SEEK knob. The scan stops automatically

 whenitndsastationofsufcientstrength.

5. After a few seconds, the display will update and show station name if RDS

information is being received.

6. Tondotherstations,presstheTUNING/SEEK knob again.

7. To seek station in an opposite direction, rotate the TUNING/SEEK knob clockwise

 (toscanfromlowfrequencytohighfrequency)orrotateanti-clockwise(toscan

 fromhighfrequencytolowfrequency),andpresstheTUNING/SEEK knob.

8. When the waveband end is reached, the radio will recommence tuning from the

opposite waveband end.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

PerfectPro SLIM 1 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info