1. Battery installation / bowl alignment
1.1 Remove feeder lid by pressing down lid and pushing in
the sprung clips on both sides (Fig. 3). Lift the food bowl
off the feeder base and remove the battery cover by
releasing the retaining clip (Fig. 4).
1.2 Insert 3 x
marked on the inside of the compartment. Replace the
battery cover
After a short period of self testing, the clock ( 3 , Fig. 2)
will show 12:00
feeding time indicators ( 5 and 6 , Fig. 2), showing
– – : – – beneath.
T
are not correctly aligned, remove lid then press
and UP buttons together to 3 seconds to achieve alignment.
Good quality alkaline batteries should normally last
approximately 12 months (dependent on use). Y
all popular batteries including rechargeable and 1.5v lithium
batteries but the low battery indicator will only work correctly
with standard alkaline batteries.
2. Setting the clock
NO
(AM/PM) formats, press and hold the ADJ/SET b
together with the DOWN arro
changes.
If at any point during setting a button is not pressed within
30 seconds, all digits will stop flashing and any adjustments
made will rev
2.1 If necessary
clock display using the UP or DOWN arrow buttons.
T
5 seconds until the hour figure starts to flash. Press the
UP or DOWN arrow buttons to adjust the clock to the
correct hour
2.2 Press the ADJ/SET
flash.
Press
3. Meal time setting
The C300 feeder will automatically serve meals at the same
time(s) every day once you have set the required meal
times. For example, if you require one meal a day you need
only set the time for MEAL
If you require 2 meals in a day you will need to set the times
of MEAL
Set your pet’s required daily meal times as follows:
NO
order (earliest to latest time) on the display
will be served at the next progr
For e
next meal will be served at 17:00.
3.1 Press the UP
highlight frame to MEAL
button for 3 seconds until the MEAL
flash. Set the hours for MEAL
arrow buttons. Press
3.2 The minute figure will flash.
DOWN arrow buttons. Press
NO
increments.
Repeat 3.1 and 3.2 for MEAL
3.3 T
arrow buttons to highlight frame the relevant meal time.
Press and hold the
flashes. Then press the UP and DOWN arrow buttons
together until the time disappears and display
shows – – : – – .
4. T
Y
and is assembled to comply with rigorous quality standards.
Consequently
use. However
operation with your cat(s) while you are in attendance by
completing set up as follows:
4.1 Fill the required number of bowls, starting clockwise
from ‘1’
required). T
order that the rotating lid is not fouled.
4.2 Insert pre-frozen ice pack and replace food bowl
aligning ‘0’
(D1, Fig. 1). (If the ‘0’
with the ‘0’
arrow buttons together for 3 seconds to achieve
alignment.)
4.3 Finally
each side click into position and place unit in required
position. The meal in the bowl numbered ‘1’
served at the next programmed meal time.
4.4 Always turn feeder off after use (see Section 9 below).
5. Especially for cats
When leaving your cat, do not forget to make adequate toilet
arrangements for it. Cats and particularly kittens, should not
be left alone for long periods without someone to check
periodically that all is well. We also recommend the use of
a CA
6. Especially for dogs
Most small dogs will readily adapt to an automatic feeder
but you are recommended to supervise your dog's first few
encounters to ensure that it is unlikely to damage the unit
- which may be a problem with puppies.
4 5
When leaving your dog, do not forget to make adequate
toilet arrangements for it. Dogs, and particularly puppies,
should not be left alone for long periods without someone
to check periodically that all is well. We also recommend
the use of a DOG MA
For extra stability the feeder may be attached to a wooden
baseplate as follows:
6.1 Remove the feeder lid and food bowl. Place feeder in
desired position on wooden board, locate the two
moulded-in retaining clips (F
hole using a suitable screw down through the centre
of each hole. (Fig 6).
6.2 Break out the retaining clips by carefully cutting
retaining webs with a sharp knife (Fig. 7).
6.3 Replace clips in holes with the flat side of the clip
uppermost and screw to board at marked screw
positions using suitable screws (Fig. 8).
6.4 T
(Fig. 9).
7. Hints on food storage
Y
The C300 should always be used with its ice pack unless
the surrounding temperature is less than 5°C. (40°F
freeze the ice pack before use, place in a freezer for at
least 6 hours. Spare ice packs are available from your
dealer or directly from www.pet-mate.com .
When using your C300 feeder with wet food, ensure that
the food comes from a freshly opened can/pack. If the
weather is very warm, you are advised not to leave wet
food for long periods and may prefer to serve dry food,
which has better keeping qualities. If in doubt, please
consult the manufacturer of your cats’
8. Positioning of feeder
The C300 feeder should be used indoors or in a garage or
outbuilding and should be placed in a cool corner
from sunlight and away from moisture.
9. T
T
press and hold the UP and DOWN arrow buttons together
until ‘OFF’
to turn the feeder back on.
10. Changing the batteries
When the low battery indicator ( 2 , Fig. 2.) flashes on the
LCD, alkaline batteries need replacing.
IMPORT
•
remove and replace all of the batteries within 60 seconds!
•
replacement of the batteries. Doing so will reset the unit
and you will need to re-programme your settings.
•
feeder is not to be used for prolonged periods.
1
The C300 feeder is very easy to clean. The lid and bowl
may be washed in a dishwasher
wiped with a damp cloth. Under no circumstances should
the base unit be immersed in water
1. Einlegen der Batterien / Ausrichten der Näpfe
1.1 Entfernen Sie den Futterbehälterdeckel, indem Sie auf den
Deckel drücken und die Klipps an beiden Seiten
hinunterschieben (Abb. 3). Heben Sie den Futternapf vom
Grundgerät ab und entfernen Sie den Batteriedeckel, indem sie
den Halteklipp lösen (Abb. 4).
1.2 Legen Sie drei AA-Batterien ein, wobei Sie unbedingt die
Richtungssymbole im Batteriefach beachten. Setzen Sie den
Batteriedeckel wieder auf.
Nach kurzem Selbsttest erscheint im LCD-Display ( 3 ,
optisch hervorgehobene Zeitanzeige 12:00
( 5 und 6 ,
Setzen Sie nun den Futternapf und den Deckel vorübergehend
wieder ein. Wenn Deckel und Napf nicht ordnungsgemäß
ausgerichtet sind, entfernen Sie den Deckel und drücken dann zum
Ausrichten 3 Sekunden lang gleichzeitig auf die T
die AUFWÄRTS-Pfeiltaste.
Alkali-Mangan-Batterien von guter Qualität halten im Normalbetrieb
ungefähr 12 Monate (je nach V
alle handelsüblichen Batterien einschließlich 1,5 V Lithiumbatterien
verwenden. Die Niedrige Batterie-Anzeige funktioniert jedoch nur mit
Alkali-Mangan-Batterien richtig.
2. Einstellen der Uhr
HINWEIS:
und dem 12-Stunden-Format (AM/PM) umzustellen, drück
gleichzeitig auf die
halten beide gedrückt, bis sich das Anzeigef
Wenn eine fällige
Sekunden gedrückt wird, hören alle Ziff
kehren die je
bzw
2.1 Falls erforderlich, verwenden Sie die
ABWÄRTS-Pfeiltasten zum V
Uhranzeige. Zum Einstellen der Uhr drücken Sie auf die
ADJ/SET
bis die Stunden-Ziffern zu blinken beginnen. Zum V
gewünschten Stundenanzeige drücken Sie auf die
AUFWÄRTS- oder
2.2 Drücken Sie auf die ADJ/SET
Minutenziffern zu blinken beginnen. Zum V
wie gewünscht auf die
Pfeiltasten. Zur Speicherung der Einstellung drücken Sie auf
ADJ/SET
IMPORT
INSTRUCTIONS
•
product.
•
Register your purchase on-line at www.pet-mate.com
(see guarantee).
• Do not allow children to play with this product.
•
damage. Do not use if in doubt.
•
described in these instructions.
• Dispose of all packaging material properly
NO
awa
SA
WICHTIGE
SICHERHEITSANWEISUNGEN
•
Produkts sämtliche
• Registrieren Sie Ihr Produkt online unter www
(siehe Garantie).
•
•
Betrieb und mögliche
Zweifelsfall soll es nicht verwendet werden.
•
Haustieren und nur wie in der vorliegenden
Bedienungsanleitung beschrieben.
•
HINWEIS:
verursachen und müssen außer Reichweite v
Tieren gehalten werden.
BITTE DIESE
AUFBEW
D
