Press one of the two start buttons 6.
(9) or
(13) to activate the venting
function. During start-up, the number
of rinsing cycles required is established
electronically. If several rinsing cycles
are necessary, each cycle is interrupted
after 45 seconds and the ready to brew
indicator
(11) flashes green again.
If necessary, empty the collecting ves-7.
sel and press one of the two start but-
tons
(9) or (13) again.
As soon as the appliance is sufficient-8.
ly rinsed, the ready to brew indicator
(11) lights up red and the water is
heated. Turn the control knob (7) to its
home position
.
Do not interrupt the rinsing cycles. Do
not remove the water container (5) and
do not pull out the power plug; other-
wise you will need to restart the start-up
process.
Coffee
Coffee soft pads
You can use all conventional coffee soft
pads with an outer diameter of 7 cm
(coffee quantity of approx. 7 g). Coffee
pads with a smaller diameter do not
deliver the best coffee. Hard pads offered
for espresso machines and pads with ad-
ditives for cappuccino and such cannot
be used.
Never fill damaged pads, loose coffee
powder or instant coffee into the pad
cartridge (4), as it will clog and block the
control knob (7) so that the pad cartridge
(4) can no longer be removed. Should
this happen nevertheless, please read
the instructions in the section “Help with
problems”.
The quantity of coffee powder in a pad
is optimised for one cup of 125 ml. The
appliance is set at the factory for the
following quantities:
Start button
(9)
approx. 125 ml ideal for 1 pad
Start button
(13)
approx. 250 ml ideal for 2 pads
You can change the strength of the
coffee by varying the filling quantity per
cup according to your personal taste and
requirements. You will find the detailed
instructions for this in the section “Pro-
gramming mode”.
Pad cartridge
Turn the control knob (7) to position
and directly back to home position
.
The will cause the pad cartridge (4) to be
pushed slightly out of the brewing cham-
ber, making it easier to remove.
The pad cartridge (4) can be used from
both sides. The side marked with is
intended for one coffee pad and the side
marked with is for two coffee pads.
The more carefully you insert the coffee
pads, the better the coffee will be. The-
refore we recommend that you adhere to
the following instructions:
Before inserting the coffee pad, distri-•
bute the powder in the pad evenly up
to the edge.
Making coffee with one coffee pad: •
Insert the coffee pad and tap it lightly
into place with your finger tips so that
a small indentation develops in its cen-
tre. Ensure that the paper edge of the
coffee pad lies flat in the recess of the
pad cartridge (4) without projecting out-
wards or folding inwards.
Making coffee with two coffee pads: •
Press the bottom pad tightly into the
recess in the pad cartridge (4), causing
its paper edge to fold upwards. Then
add the second coffee pad following
the procedure described above for one
coffee pad.
When pushing the pad cartridge (4) into •
the appliance, make sure that the pad
does not shift, otherwise the seal will
not work reliably.
