Bedienungsanleitung Petsafe PIG00-11115 (Seite 13 von 19) (Englisch)

770991

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

petsafe.com1-800-732-2677 2524

Steps:

1. Repeat steps 1–3 in Phase 1, this time allowing your pet to stay in the

correction zone long enough to be corrected.

2. Observe whether or not your pet seems to feel the correction. A slight

change in your pet’s behavior, such as looking around in curiosity,

scratching at his collar or flicking his ears, indicates your pet’s recognition

level. If your pet does not respond to the static correction, confirm that the

receiver collar is fitting properly according to Step 12 on page 21.

3. If the receiver collar is fitted properly and your pet does not respond to

the static correction, increase the static correction level by one setting.

Continue to observe whether your pet is looking around in curiosity,

scratching at his collar or flicking his ears.

4. Stay at the same flag until your pet resists going into the static

correction zone.

Phase 3

Days 5 Through 8—Distraction Phase

Perform 3 training sessions per day, each lasting 10–15 minutes.

Goal:

To train your pet to stay within the pet area with distractions outside of the

pet area.

Setup:

• Program the static correction level on the receiver collar to level 2 or

higher, depending on the reaction results from days 2 through 4.

• Put a separate non-metallic collar on your pet’s neck below the receiver

collar and attach a leash.

Be sure the extra collar does not put pressure on the contact points.

• Have small pieces of your pet’s favorite treats available.

• Have your pet’s favorite play toy available.

• Stage some distractions to tempt your pet to enter the static correction

zone. Start with temptations that are of lower value for your pet, and work

your way up. It is typically harder for pets to resist temptations that are

close by than those further away:

- Have a family member cross from inside the pet area to outside of it.

- Place a ball, treat or toy outside of the pet area.

- Have a neighbor walk their pet outside of the pet area.

• Gradually increase distraction level.

Never coax or call your pet out of the pet area.

Steps:

1. With full control of your pet on a leash, have the distraction presented.

2. If your pet does not move toward the distraction, praise and offer a treat.

3. If your pet does react to the distraction, allow him or her to go into the

static correction zone while still on the leash.

4. Help your pet back into the pet area if he or she does not turn back after

2 seconds.

5. Treat and praise your pet anytime he or she comes back into the pet area

with or without help.

6. Repeat this process with other distractions. Use other family members

during this process.

7. If your pet does not respond to the static correction, confirm that the

receiver collar is fitting properly according to Step 12 on page 21.

8. If the receiver collar is fitted properly and if your pet does not respond to

the static correction, increase the static correction level by one setting.

Phase 4

Days 9 Through 14—Unleashed Supervision

Training sessions should start at 10-15 minutes, gradually increasing to over

an hour.

Your pet is ready for this step only when he or she clearly avoids the entire

static correction zone, regardless of any distractions or temptations. During

this step, do not leave your pet unattended.

Goal:

To give your pet free run of the pet area off the leash.

Setup:

• Adjust the static correction level to the permanent setting appropriate for

your pet.

• Put a separate non-metallic collar on your pet’s neck below the receiver

collar. Keep a leash close by to use in case your pet escapes the

pet area.

Steps:

1. Enter the pet area with your pet wearing the receiver collar.

2. Walk around the yard and play with your pet, staying within the pet

area at all times (13D).

3. Preoccupy yourself with another task in the yard while watching

your pet.

4. Should your pet escape, take the receiver collar off and lead him back

into the pet area.

Phase 5

Days 15 Through 30—Pet Monitoring

Your pet is ready to run! Just make sure to check on your pet at

regular intervals.

Note: After you are satisfied that your pet’s training is complete, remove

every other boundary flag every 4 days until all flags are removed. Save

your boundary flags for future use.

Taking Your Pet Out of the Pet Area

Important: Remove the receiver collar and leave it at home.

Once your pet learns the boundary, he will be reluctant to cross it for walks

or car rides.

Option 1:

Replace the receiver collar with a regular collar. Put your pet in a car that is

within the pet area and drive him out of the pet area (13E).

Option 2:

Replace the receiver collar with a regular collar and leash. Walk your pet

out of the pet area while giving a command such as “OK” at a specific

place along the boundary (the end of your driveway, sidewalk, etc.).

Always leave the pet area from the same spot in your yard with a leash

and your pet will associate leaving the pet area only on a leash, only at this

spot, and only with a person. You may initially need to convince your pet to

leave the pet area with a treat and lots of praise.

Note: You may also carry your pet out of the pet area.

Congratulations! You have now completed the training program. You are

both ready to enjoy more freedom. Just make sure to continue to check the

tightness of the receiver collar and remove it when it is not in use.

13D

13E

Petsafe PIG00-11115 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info