Bedienungsanleitung Philips 32HFL5014 (Seite 34 von 138) (Deutsch)

706058

Zoom out

Zoom in

Vorherige Seite

1/138

Nächste Seite

Problems

Wireless network not found or distorted

• Microwave ovens, DECT phones or other Wi-Fi

802.11b/g/n/ac devices in your proximity might

disturb the wireless network.

• Make sure that the firewalls in your network allow

access to the TV's wireless connection.

• If the wireless network does not work properly in

your home, try the wired network installation.

Internet does not work

• If the connection to the router is OK, check the

router connection to the Internet.

The PC and Internet connection are slow

• Look in your wireless router's user manual for

information on indoor range, transfer rate and other

factors of signal quality.

• Use a high-speed (broadband) Internet connection

for your router.

DHCP

• If the connection fails, you can check the DHCP

(Dynamic Host Configuration Protocol) setting of the

router. DHCP should be switched on.

Wired Connection

What You Need

To connect the TV to the Internet, you need a

network router with a connection to the

Internet. Use a high-speed (broadband) connection

to the Internet.

Make the Connection

Make the Connection - WIRED

Press 

Home >  Settings >  Wireless and

Networks > Connect to Network > WIRED.

1 - Connect the router to the TV with a network cable

(Ethernet cable**).

2 - Make sure that the router is switched on.

3 - The TV constantly searches for the network

connection.

4 - A message will be shown when the connection is

successful.

If the connection fails, you can check the DHCP

setting of the router. DHCP should be switched on.

**To fulfill EMC regulations, use a shielded FTP Cat.

5E Ethernet cable.

Settings

View Network Settings

Press

 Home >  Settings >  Wireless and

Networks > Settings > View Network Settings.

You can view all current network settings here. The IP

and MAC address, signal strength, speed, encryption

method, etc.

Network Configuration - DHCP / Static IP

Press  Home >  Settings >  Wireless and

Networks > Settings > Network Configuration >

DHCP / Static IP .

Select DHCP or, if you are an advanced user, you can

setup your network with static IP addressing.

Network Configuration - Static IP Configuration

Press  Home >  Settings >  Wireless and

Networks > Settings > Static IP Configuration.

1 - Select Static IP Configuration and configure the

connection.

2 - You can set the number for IP

Address, Netmask, Gateway, DNS 1, or DNS 2.

Wake on LAN (WoL)

Press  Home >  Settings >  Wireless and

Networks > Settings > Wake on LAN (WoL).

Disable/Enable Wake on LAN (WoL). You may wake

up TV using an external device on the same LAN.

Wake on Wi-Fi (WoWLAN)

Press  Home >  Settings >  Wireless and

Networks > Settings > Wake on Wi-Fi (WoWLAN).

Disable/Enable Wake on Wi-Fi (WoWLAN). You may

wake up TV using an external device on the same Wi-

Fi.

Network Type

Press  Home >  Settings >  Wireless and

Networks > Settings > Network Type.

• Wired - Connecting to a wired network.

• Wireless - In the list of found networks, select on

your wireless network. If your network is not in the list

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips 32HFL5014 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Philips 32HFL5014

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info