Bedienungsanleitung Philips 70fc566 (Seite 3 von 56) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

780732

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

English

CONNECTIONS

INTRODUCTION

This

auto reverse cassette decl< is suitabie for use

with

ferro, chromium and metai

cassettes.

The

cassettes

do not have to be turned over at the end

of the tape: the direction of tape travel can be

reversed

automatically at the end of the

cassette,

whereafter

recording or playback is continued on

the other side of the

cassette.

The

cassette deck is equipped

with

the Dolby B and

Dolby C NR (Nolse Reduction)

system,

manufac-

tured under llcense

from

Dolby Laboratories

Licen-

sing

Corporation.

'DOLBY'

and the double-D symbol •• are trade-

rrarks

of Dolby Laboratories Licensing Corpora-

tion.

The

copying of gramophone records and the

recording of radio programmes is only permitted if

there is no infringement of copyrights or other

rights of

third

parties.

Note

for

users

in U.K.

Recording

and playback of material may require

consent.

See Copyright Act 1956 and The Perform-

ers'

Protection Acts 1958 to 1972.

INSTALLATION

• Remove all protective materials after unpacking.

• Do not place the

unit

or the

cassettes

for any

length of time in direct sunlight or other places

where

high temperatures can occur, such as near

heating equipment.

• Do not exposé the

unit

to damp or rain.

•

This

cassette deck incorporates microproces-

sors.

case

of any malfunctioning due to static

electricity etc, just switch OFF the mains and

switch

ON again after approx. 30 seconds.

• Always install the cassette deck horizontally.

• When the cassette deck is installed on or near

other audio equipment, sometimes hum may occur.

Try

a different position in that

case.

Usually the

cassette

deck will be positioned at the

bottom

of a

stack.

Fig.

For

the connection

equipment

without

recorder

connection

e.g.

televisions,

it is

necessary,

for

reasons

of safety, to consult your

dealer

® 'L - OUT and R - OUT' line outputs

For

connecting the cassette deck to the inputs

'TAPE

1 L-HR IN' or

'TAPE

2 L-l-R IN' of the

amplifier

'L - IN and R - IN' line inputs

For

connecting the cassette deck to the

outputs

'TAPE

1 L-l-R OUT' or

'TAPE

2 L-l-R

OUT'

of the amplifier.

For

setting the cassette deck to the local mains

voltage.

Warning: Before connecting the cassette deck

to the mains, check that the voltage setting of

voltage selector © corresponds

with

to local

mains

voltage.

Mains lead socket

For

connecting the cassette deck to the mains.

The

type plate is on the rear of the

cassette

deck.

Important note for

users

in U.K.:

When

fitting

a mains plug to the mains lead proceed as follows:

The

wires in the mains lead are coloured in accordance

with

the

following

code: Blue = Neutral, Brown =

Live.

these colours may not correspond to the colour markings

identifying the terminals in your plug proceed as follows:

The

Brown wire must be oonnected to the terminal which is

marked

with

the letter L or coloured Red.

The

Blue wire must be connected to the terminal which is marked

with

the letter N or coloured

Black.

Note:

This

apparatus must be protected by a 3 Amp

Fuse

if a

Ampplugisusedor, ifanyothertypeof plugisused,bya5 Amp

Fuse

either in the plug or adaptor or at the

distribution

board. If in

doubt

consult a qualified electrician.

CONTROLS

AND THEIR FUNCTION

Fig.

'ON/OFF'

switch

For

switching the whole

unit

on and off.

@ 'EJECT'

button

For

opening the cassette holder @.

Cassette

holder

See

fig. 4 for insertion of the

cassette.

The type

of cassette which is being used is shown on the

display.

See

'TYPES

TAPE'.

'COUNTER

MEMORY'

button

Pressing

this

button

will store the counter

reading in the memory. See

'COUNTER

MEMO-

RY'.

'COUNTER

RESET'

button

Pressing

this

button

makes the counter ®

return to '0000'. By setting the counter to '0000'

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips 70fc566 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info