Bedienungsanleitung Philips 70fc566 (Seite 5 von 56) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

780732

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Remarks about the reverse mode facility

• The cassette deck will not enter the recording

mode if the two tabs have been removed trom the

cassette (see Fig. 3).

• If only the tab for side 2 (or side B) has been

removed,

the cassette deck will stop at the end of

the recording on side 1 (or side A).

• Preferably use cassettes with transparent leader

tape.

When using cassettes with untransparent

leader tape, the QUICK reverse will not operate. In

that case, the tape will reverse about 4 seconds

after stopping at the end of the cassette.

• When recording in the modes as shown in Fig. 7b

or Fig. 7c, the first 0.3 seconds of the second side

will nof be erased. Therefore, a previous recording

on that part of the tape should be erased in advance

(in the Fig. 7a mode).

• During the quick reverse operation, the input

channels are muted for about 0.8 seconds.

RECORDING

1. Ensure that the cassette deck has been con-

nected as described under 'CONNECTIONS'

and that the mains voltage has been switched

on with the power 'ON/OFF' switch ©. The

'REVERSE MODE' indicator indicates the mode

of Fig. 7b. The direction indicator BH will

indicate the direction of tape travel. This will be

the direction which was used during previous

use of the cassette deck.

2. Open the cassette holder @ by pressing

'EJECT' button @.

3. Place a cassette which is nof protected against

recording in the cassette holder, with the open

side down, and the full reel on the left. Close the

cassette holder.

If the direction indicator shows the

direction,

then press the 'PLAY >' button © and the

'STOP'

button @ immediately thereafter.

The direction indicator then changes to the >

direction.

4. If you so wish, switch on the Dolby B or C

system.

5. Set your amplifier to the sound source from

which you wish to record or connect the

microphones to the cassette deck.

6. Press the 'PAUSE' button (u) and then (with the

'PAUSE'

button held pressed), press the 'REC'

button @. The cassette deck is now in position

recording/pause, which is confirmed by the

indicators (the 'PAUSE' indicator will flash).

Does the 'REC' indicator @ not light up?

- Then a cassette which is protected against

recording is in the deck.

Put another cassette in the deck.

7. Let the connected unit play or speak/sing into

the microphone(s) and set the recording level

with the Controls @ in such a way that the

recording level indicators @ light up to the

section during passages of average volume,

see Fig. 5. An overshoot of up to +3 dB during

peaks is normal.

8. Differences between the left-hand and right-

hand channels can be corrected by setting the

two Controls @ differently, see Fig. 6.

Do the recording level indicators @ not light up

(well)?

- Check that the 'REC' indicator @ is lit up. If not,

see point 6. above..

- Check that the required sound source has been

properly connected.

- Check that the amplifier setting is correct.

- Check whether a sound source other than the

required one does function properly.

9. Now start the recording by pressing 'PAUSE'

button @ again.

10. Check the recording level from time to time;

adjust if necessary. s

11. To stop the recording, press 'STOP' button (g).

Notes

• By immediately pressing the fast wind button '«'

after the recording (thus not the 'STOP' button @

first) the tape is quickly rewound to the beginning

of the recording just made. The tape then stops

automatically.

N.B. After recording in the direction

you must

press the fast wind button '»'!

• If you only want to record one side of the

cassette, before recording press button 'RE-

VERSE MODE' @ until the 'REVERSE MODE'

indicator lights up as illustrated in Fig. 7a.

SILENT RECORDING 'REC MUTE'

When pressing 'REC MUTE' button @ during

recording,

a silent passage of 4 seconds will be

inserted,

after which the cassette deck will stop in

the recording/pause mode. Undesired interrup-

tions,

such as announcements etc. will not be

recorded in this way.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips 70fc566 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info