Bedienungsanleitung Philips EP2230 (Seite 17 von 28) (Englisch)

684444

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

7 The first phase of the descaling procedure starts. The descaling procedure lasts approx. 30 minutes

and consists of a descaling cycle and a rinsing cycle. During the descaling cycle the Calc / Clean

light flashes to show that the descaling phase is in progress.

8 Let the machine dispense the descaling solution until the display reminds you that the water tank

is empty.

9 Empty the water tank, rinse it and then refill it with fresh water up to the Calc / Clean indication.

10 Empty the container and place it back under the coffee dispensing spout and the water spout.

Press the start/stop

button again.

11 The second phase of the descaling cycle, the rinsing phase, starts and lasts 3 minutes. During this

phase the lights on the control panel go on and off to show that the rinsing phase is in progress.

12 Wait until the machine stops dispensing water. The descaling procedure is finished when the

machine stops dispensing water.

13 The machine will now heat up again. When the lights in the drink icons light up continuously, the

machine is ready for use again.

14 Install and activate a new AquaClean water filter in the water tank (see 'Activating the AquaClean

water filter (5 min.)').

When the descaling procedure is finished, the AquaClean light flashes for a while to remind you

to install a new AquaClean water filter.

Tip: Using the AquaClean filter reduces the need for descaling!

What to do if the descaling procedure is interrupted

You can exit the descaling procedure by pressing the on/off button on the control panel. If the

descaling procedure is interrupted before it is completely finished, do the following:

1 Empty and rinse the water tank thoroughly.

2 Fill the water tank with fresh water up to the Calc / Clean level indication and switch the machine

back on. The machine will heat up and perform an automatic rinsing cycle.

3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first

dispense half a water tank of hot water by repeatedly tapping the hot water icon (Fig. 14) and then

brew 2 cups of pre-ground coffee without adding ground coffee.

If the descaling procedure was not completed, the machine will require another descaling

procedure as soon as possible.

Ordering accessories

To clean and descale the machine, only use the Philips maintenance products. These products can be

purchased from your local retailer, from the authorized service centers or online at

www.philips.com/parts-and-accessories. To find a full list of spare parts online, enter the model

number of your machine. You can find the model number on the inside of the service door.

Maintenance products and type numbers:

Descaling solution CA6700

AquaClean water filter CA6903 (Fig. 46)

Brew group grease HD5061

Coffee oil remover tablets CA6704

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips EP2230 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Philips EP2230

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info