Bedienungsanleitung Philips N2543 N2544 (Seite 3 von 51) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

780731

Zoom out

Zoom in

Vorherige Seite

1/51

Nächste Seite

tape has a layer of chromium dioxide, press tape

selector

®.

• When using ferro-chrome

cassettes,

made

from

mixture of ferric oxide and chromium dioxide,

press

tape selector ®.

• Muslcassettes are Compact

Cassettes

contain-

ing prerecorded music. Muslcassettes are

safe-

guarded against accidental erasure.

Controls

and connection

sockets

Figures

1 and 4

socket for stereo headphones

socket for the

left

channel microphone

socket for the

right

channel microphone

® tape selector - ferro

® tape selector - chromium

on/off

switch for Dolby system

® recording indicator

® eject key

record key

fast rewind/'review' key

start key

(g)

fast forward wind/'cue' key

pause key

stop key

mains

on/off

switch

cassette holder

counter

zero reset

button

for counter

on/off

switch for zero stop

on/off

switch for FM

pilot-tone

suppression

filter

(MPX) and radio interference

filter

(RIF)

recording level control -

right

channel

recording level control -

left

channel

recording level meter -

right

channel

overload/peak indicator -

both

channels

recording level meter -

left

channel

line out socket -

left

channel

(g)

line out socket -

right

channel

(g)

line in socket -

left

channel

line in socket -

right

channel

output

level control ~

left

channel

output

level control -

right

channel

socket for stereo microphone, radio, amplifier,

gramophone combination or second recorder.

The

type plate is at the

base

of the recorder.

Note:

Do not exposé the recorder for any great

length of time to

excessive

heat

from

heating

equipment or direct sunshine.

Connecting

the recorder to the mains

Before

connecting the recorder to the mains,

ensure

that the voltage on the type plate on the

base

corresponds to your local mains supply. If it Is

not in accordance

with

your mains voltage contact

your dealer who can adjust the setting.

If the setting is correct you may proceed to connect

to the mains.

Warning: Always disconnect the mains lead before

opening the apparatus.

Note

for

users

in Great Britain

When

fitting

a mains plug to the mains lead proceed as follows;

The

wires in the mains lead are cotoured in accordance

with

the

following

code: Blue = Neutral, Brown =

Live,

As these colours

may

not correspond

with

the coiour mari<ings identifying the

terminals in your plug proceed as follows:

The

Brown wire must be connected to the terminal which is

marked

with

the letter L or coloured Red.

The

Blue wire must be connected to the terminal which is marked

with

the letter N or coloured

Black.

Note:

This

apparatus must be protecled by a 3 Amp

Fuse

if a 13

Amp plug is used or if any other type of plug is used by a 5 Amp

Fuse

either in the plug or adaptor or at the

distribution

board If in

doubt

consult a qualified electrician.

Switching

on and off

• Switching on:

Press

mains switch @; the record-

ing level meters @ and @ and the cassette holder

now

light.

• Switching off:

Press

mains switch @ again; the

lights now go out.

Note:

Never switch off the recorder while the tape

motion

without

first pressing stop key

since

such

action may result in damage to the tape and

the recorder.

Inserting and removing the cassette

• Inserting:

Press

eject key @; cassette holder @

will now open. With the

full

reel on the left-hand side

and the tape downwards, slide the cassette fully

info

the holder as shown in Fig. 2. After this, close

the cassette holder.

• Removing:

Press

eject key @; the cassette

holder will open and the cassette can be removed.

Note:

Eject

key @ also

serves

as a stop key.

Counter

with zero stop

Make a habit of setting counter @ to '000', by

pressing

zero reset

button

@, immediately after

inserting a cassette. By

noting

the counter reading

at which each recording commences, you will later

be able to locate any of your programmes rapidly by

fast

winding or rewinding to the same reading.

Note:

The counter does not directly indicate the

playing time of the cassette, The zero stop is

switched on when switch

(g)

is pushed in. With the

zero

stop switched on, the tape stops during fast

rewinding when the indicator reaches '000'. The

start of a recording just made can be located

automatically as follows: Set the counter @ to '000'

at the start of the recording and press the zero stop

switch @ and the rewind key (jj) at the end. The tape

will rewind and stop automatically when the start

point

is reached.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips N2543 N2544 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info