489712
12
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
• 12 •• 12 •
The machine begins the dispensing
phase. The
icon will be displayed
to show which button is being pro-
grammed.
Press the button with the
icon
again when the desired amount of
co ee in the cup is reached.
At this point the button
“ is pro-
grammed; each time it is pressed and
released, the machine will brew the
same amount of co ee that was just pro-
grammed.
Stand-By
The machine is designed for energy sav-
ing. The machine automatically turns o
after 30 minutes of inactivity.
Note: During the switching
o phase, the machine per-
forms a rinse cycle, if a co ee product
has been brewed.
To turn the machine on again, simply
press the ON/OFF button (if the power
button is set to “I”). In this case the ma-
chine will go through the rinse cycle only
if the boiler is cold.
COFFEE BREWING
Note: Should the machine not
brew co ee, make sure that
the water tank contains water.
Before brewing co ee, check
the messages on the display.
Check that the water tank and co ee
bean hopper are full.
Leave the dial on the co ee
position
during the dis-
pensing phase.
Before brewing the cof-
fee, adjust the height of the
dispensing spout according to your
needs, and select the aroma or the
pre-ground co ee.
Green
Green
bean hopper.
Do not pour co ee beans when the
co ee grinder is working.
The machine allows slight adjustments to
the co ee grinder to adapt it to the kind
of co ee used.
To make any adjustment, press and turn
the knob inside the co ee bean hopper.
Press and turn the knob by one notch at
a time and brew 2-3 cups of coffee; this
is the only way to notice differences in
grind.
The reference marks inside the coffee
bean hopper indicate the grind setting.
There are 5 different grind settings to
choose from with the following refer-
ences:
Large Dot - Coarse Grind
Small Dot - Fine Grind
Green
Adjusting the Co ee Quantity
The machine allows you to adjust the
amount of brewed coffee according to
your tastes and/or the size of your cups.
Each time you press and release button
“ or , the machine brews a
pre-programmed amount of co ee. This
amount may be reprogrammed to your
taste. Each button may be individually
programmed for a speci c brew setting.
As an example, the following procedure
describes the programming of the button
, which is normally associated with
espresso co ee.
Place a cup under the dispensing spout.
Press and hold the
“ button, until
the relevant icon is displayed. At this
point, the machine is programming it.
Black
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Philips-Saeco HD8836 Syntia wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Philips-Saeco HD8836 Syntia

Philips-Saeco HD8836 Syntia Bedienungsanleitung - Deutsch - 28 seiten

Philips-Saeco HD8836 Syntia Zusatzinformation - Holländisch - 3 seiten

Philips-Saeco HD8836 Syntia Bedienungsanleitung - Holländisch - 24 seiten

Philips-Saeco HD8836 Syntia Bedienungsanleitung - Französisch - 28 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info